top of page

Standards and Certifications Guide: ASTM, ISO, API, ASME, NACE, IEC and EU Standards for Test and Process Equipment

Writer: Tech Inc
Tech Inc
1 day ago
3 min read

Updated: 3 minutes ago

Every enquiry we receive names standards: a sampling practice, a pressure code, a materials standard, a hazardous-area certificate, a calibration requirement. This page collects our guides to the ones that come up most, written from each standard's published scope with our own commentary on what it means for the equipment. Each guide is one page; new guides are added here as they are written.

ASTM: sampling and vapour pressure

ASTM: membranes, materials and rock

  • ASTM D4194: operating characteristics of RO and NF devices.

  • ASTM D4516: normalising RO permeate flow and salt passage.

  • ASTM D6908: integrity testing of water filtration membranes.

  • ASTM F316: bubble point and mean flow pore size.

  • ASTM D882: tensile testing of thin films and membranes.

  • ASTM D6556: BET surface area by nitrogen adsorption.

  • ASTM B923: skeletal density by gas pycnometry.

  • ASTM D7012: compressive strength and moduli of rock, triaxial.

ASTM: corrosion and cleaning

  • ASTM G48: pitting and crevice corrosion in ferric chloride.

  • ASTM A380: cleaning, pickling and passivation of stainless steel.

  • ASTM G93: cleaning for oxygen service.

ISO

API and GPA

ASME

AMPP / NACE

IEC, ISA and IEEE

European directives and certificates

Wellhead, valves and flanges

Measurement, control and relief

  • ISO 5167: orifice plates, nozzles and Venturi tubes.

  • IEC 60534: control valve sizing, characteristics and noise.

  • ISO 4126: safety valves and bursting discs, the European route.

Vessels, materials and offshore safety

  • EN 13445: unfired pressure vessels, compared with ASME VIII.

  • ISO 21457: materials selection and corrosion control.

  • ISO 17776 and ISO 13702: major accident hazard management and fire and explosion control offshore.

How we use them

Standards appear on our datasheets only where the equipment is actually designed, built or tested to them, and the test certificate we issue with every system names the standards and the instruments used. Where a contract names an edition, we work to that edition. Our calculators and converters do the arithmetic many of these standards call for.

Send the standards your contract names to mail@techincresearch.com or call +1 (289) 622-1032, and we will return a configuration, datasheet and quotation built to them.

These articles are our commentary on each standard's published scope, not substitutes for the standards themselves; always work to the current edition named in your contract. Equipment specifications may change.

Comments


bottom of page