ISO 4126 Explained: Safety Valves, Bursting Discs and the European Route to Overpressure Protection

API 520 and ASME Section VIII govern relief devices in North America and much of the oil and gas world; where a project follows European or ISO practice, the reference is the ISO 4126 series, Safety devices for protection against excessive pressure, harmonised under the Pressure Equipment Directive as EN ISO 4126.
The parts
Part 1, Safety valves (2013): design, manufacture, testing and marking of direct spring-loaded safety valves; the certified coefficient of discharge K_d (and the derated K_dr), set pressure tolerances, overpressure and blowdown limits, and the type-test procedure that certifies a valve's capacity.
Part 2, Bursting disc safety devices: types, performance, marking and the burst-pressure tolerance; Part 3 covers safety valves and bursting discs in combination.
Part 4, Pilot-operated safety valves; Part 5, Controlled safety pressure relief systems (CSPRS); Part 6, Application, selection and installation of bursting disc devices.
Part 7, Common data: the sizing equations for gas, steam and liquid, including critical and subcritical flow and the viscosity correction, in the same form as the API equations but with the ISO certified coefficients.
Part 9, Application and installation of safety devices (excluding bursting discs); Part 10, Sizing for two-phase flow, based on the omega method.
Part 11, Performance testing.
How it differs from API 520
The physics is the same; the differences are administrative and in the coefficients. ISO 4126 certifies the valve's K_d by type test under the standard, the European market requires CE marking under PED Category IV for safety accessories, and the flow areas are the actual flow areas rather than the API 526 letter orifices. A valve certified under both regimes is common from the major makers.
Our equipment
Relief devices on skids and reactors delivered into PED territory are specified and certified under ISO 4126 through our European entity; the API 520 and API 521 guide covers the North American route, the PED guide the directive, and the relief valve sizing calculator does the preliminary arithmetic that both share. All our standards guides.
Send your application, materials and the standards your contract names to mail@techincresearch.com or call +1 (289) 622-1032, and we will return a configuration, datasheet and quotation.
This article is our commentary on the standard's published scope, not a substitute for the standard itself; always work to the current edition named in your contract. Equipment specifications may change; performance depends on the application, how the equipment is used and operation in line with the operation manual.
Sources
ISO, ISO 4126-1:2013 Safety devices for protection against excessive pressure, Part 1: Safety valves, standard summary page.
BSI Knowledge, BS EN ISO 4126-1 safety valves, summary page.





Comments