API 520 and API 521 Explained: Sizing, Selection and Installation of Pressure-Relieving Devices

Every pressure vessel, skid and sample system has a relief device, and in the oil, gas and chemical industries that device is sized and installed to two API standards: API 520 for the device and API 521 for the scenarios and the relief system.
API 520: sizing, selection and installation
API Standard 520, Sizing, Selection, and Installation of Pressure-relieving Devices, has two parts. Part I (tenth edition, 2020) covers sizing and selection: pressure-relief valve types (conventional, balanced-bellows, pilot-operated), rupture disks and their combinations, and the sizing equations for vapour and gas (critical and subcritical flow), steam, liquid and two-phase flow, including the effect of back pressure and the rupture-disk combination capacity factor. Part II (seventh edition, 2020) covers installation: inlet pressure drop limits, discharge piping, reaction forces, block valves and the arrangements that keep a relief device able to do its job.
API 521: pressure-relieving and depressuring systems
API Standard 521 (seventh edition, 2020) covers the causes of overpressure (blocked outlet, external fire, control failure, heat exchanger tube rupture, utility failure and others), how to determine the relieving rate for each, the design of relief and depressuring systems, and disposal: flare headers, knock-out drums, flares and vents.
How it reaches a skid or a sample system
A sample panel with a cylinder, a regulator and a cooler is a small pressure system: the regulator failure case sizes its relief; the relief discharges to a vent or flare at a defined back pressure; the inlet line to the relief has a pressure-drop limit. Reactors and autoclaves use the same rules under ASME Section VIII. Rupture disks protect against the fastest events; relief valves reseat.
Our equipment
High-pressure back-pressure regulators, sample conditioning systems, the high-pressure reactors range and every skid we build carry relief devices sized to these standards and documented in the data book; the pressure unit converter keeps set pressures in gauge and sizing in absolute. All our standards guides.
Send your application, materials and the standards your contract names to mail@techincresearch.com or call +1 (289) 622-1032, and we will return a configuration, datasheet and quotation.
This article is our commentary on the standard's published scope, not a substitute for the standard itself; always work to the current edition named in your contract. Equipment specifications may change; performance depends on the application, how the equipment is used and operation in line with the operation manual.
Sources
API, API Standard 520 Part I, Sizing, Selection, and Installation of Pressure-relieving Devices: Sizing and Selection, API announcement page.
BSI Knowledge, API 520 Part 1 summary.





Comments