top of page

Pressure Unit Converter with Gauge, Absolute and Vacuum: bar, psi, kPa, kg/cm², mmHg and Head

Writer: Tech Inc
Tech Inc
1 day ago
2 min read

Half of all pressure errors are a missing "g" or "a". This converter keeps gauge and absolute in separate tables, handles vacuum readings, and uses the atmospheric pressure at your site altitude rather than sea level.

How it works

Absolute = gauge + atmospheric; vacuum readings are atmospheric − reading. Atmospheric pressure from altitude by the ISA relation 1013.25 (1 − 2.25577 × 10⁻⁵ h)^5.25588 mbar, or enter the barometer reading. Conversion factors: 1 bar = 10⁵ Pa = 14.5038 psi = 1.01972 kg/cm²; 1 atm = 1.01325 bar = 760 mmHg = 10.33 m H₂O.

Worked example

10 bar(g) at sea level is 11.01 bar(a), 159.7 psia, 10.87 atm; as gauge it is 145.0 psig, 10.2 kg/cm², 1,000 kPa(g). At 2,000 m altitude the same gauge reading is only 10.80 bar(a).

Limits

Gas laws, compressibility, vapour pressure and relief-valve set pressures each need the right one of the two; the converter does not know which, so check the context. Head units assume water at 4 °C; for other fluids multiply by their specific gravity. Our high-pressure back-pressure regulators, pressure gauge calibration systems and high-pressure hydrostatic test units are specified in gauge unless stated. All Tech Inc. calculators and converters.

Write to mail@techincresearch.com or call +1 (289) 622-1032.

Disclaimer: this calculator and article give estimates from simplified, published equations and the values you enter, for general information only and without warranty. They are not engineering, design, safety or regulatory advice and are no substitute for measurement, the equipment or chemical maker's instructions, the applicable standards or the judgement of a qualified engineer. Do not rely on them for safety-critical decisions. Tech Inc. accepts no liability for loss, damage or injury arising from their use. Equipment specifications are typical and may change; results depend on the fluids and conditions, how the equipment is used and operation in line with the operation manual. See our product information disclaimer and terms of use.

Sources

Comments


bottom of page