top of page

Automatic SDI Analysers and ASTM D4189: A Checklist for Results You Can Defend

Writer: Tech Inc
Tech Inc
2 days ago
2 min read

Automatic SDI analysers take the stopwatch and the operator out of the test, which removes much of the variation in manual SDI. They only give defensible results, though, if they follow the method. Use this checklist when you specify, commission or audit one.

1. Pressure

  • The test runs at a constant 207 kPa (30 psi). The analyser should regulate pressure and log it for every test.

  • A pressure fault during a test should void that result, not average it in.

2. Line flushing and air removal

  • The sample line should flush before each test, so the water tested is current, not water that sat in the line.

  • Air in the holder distorts flow; the sequence should vent it before timing starts.

3. Filter

  • A fresh 0.45 µm, 47 mm filter for every test. Where filters are changed automatically, check the filter stock is sized to the test frequency.

  • Filters from one source and lot, because ASTM D4189 notes that SDI can vary with the filter manufacturer. See why SDI results differ.

4. Timing and volume

  • ti and tf measured for the same filtrate volume, by a flow or volume sensor rather than estimated.

  • The interval T selectable (15, 10 or 5 minutes).

5. Plugging check

  • The analyser should calculate %P and flag any result above 75% rather than report it as a valid SDI15; see the 75% rule.

6. Temperature

  • Water temperature logged with every result, because SDI is not temperature corrected.

7. Records

  • Each result stored with date, time, T, ti, tf, %P, pressure and temperature, and exportable to the plant control system.

8. Checks

  • A periodic manual SDI on the same sample point with a manual kit confirms the analyser.

Our analysers

The Silton 4950 Pro, Silton 4950 Pro Max for seawater and Silton 4750 Max run the D4189 sequence automatically, calculate SDI and plugging factor, log every result and raise an alarm when a limit is crossed. Send us your sample points and we will confirm the configuration against this checklist. See the full range on SDI Measurement.

Write to mail@techincresearch.com or call +1 (289) 622-1032.

Equipment specifications are typical and may change. SDI results depend on the water, the filters, how the equipment is used and operation in line with the operation manual.

Sources

Comments


bottom of page