top of page

EN 13445 Explained: The European Unfired Pressure Vessel Standard and How It Compares with ASME VIII

Writer: Tech Inc
Tech Inc
3 minutes ago
2 min read

A vessel sold into the European Economic Area is CE-marked under the Pressure Equipment Directive, and the harmonised standard that gives presumption of conformity for unfired vessels is EN 13445, Unfired pressure vessels (2021 edition with amendments). It is the European counterpart of ASME Section VIII.

The parts

  • Part 1, General; Part 2, Materials (European steel standards, the EN 10204 certificate types required by testing group, and the rules for materials not in a harmonised standard);

  • Part 3, Design: design by formula for shells, heads, openings, flanges and supports, with the allowable stresses derived by the standard's safety factors from the material's yield and tensile properties, and the design-by-analysis routes (direct route and stress categorisation) and fatigue assessment;

  • Part 4, Fabrication (welding, forming, heat treatment); Part 5, Inspection and testing: the testing groups 1 to 4 that set the extent of NDE (from 100% to visual only, with corresponding joint coefficients) and the hydrostatic test pressure;

  • Part 6, Spheroidal graphite cast iron; Part 8, Aluminium alloys; Part 10, Nickel alloys.

How it compares with ASME Section VIII Division 1

The physics and most results are similar; the differences are in allowable stress basis (EN 13445 uses yield-based factors that often give thinner walls for high-strength steels), in the testing-group concept replacing the ASME joint-efficiency and RT options, in the material standards referenced, and in the conformity route: EN 13445 vessels are CE-marked through a notified body by PED category; ASME vessels are U-stamped through an authorised inspector. A vessel can be designed to ASME and CE-marked, or designed to EN 13445 and accepted by many non-European clients; the contract decides.

Our equipment

Reactors, autoclaves and skid vessels for European clients are designed to EN 13445 or to ASME VIII with CE marking, as the contract specifies, with EN 10204 3.1 certificates and the notified-body involvement the PED category requires. See the PED guide, the ASME Section VIII guide and the EN 10204 guide; the standard high-pressure reactor range and jacketed high-pressure vessels are built to either route. All our standards guides.

Send your application, materials and the standards your contract names to mail@techincresearch.com or call +1 (289) 622-1032, and we will return a configuration, datasheet and quotation.

This article is our commentary on the standard's published scope, not a substitute for the standard itself; always work to the current edition named in your contract. Equipment specifications may change; performance depends on the application, how the equipment is used and operation in line with the operation manual.

Sources

Comments


bottom of page