EN 10204 Explained: Material Test Certificates, Types 2.1, 2.2, 3.1 and 3.2

Every pressure vessel, skid and sampling panel arrives with a stack of material certificates, and every one of them is a type defined by one short European standard: EN 10204, Metallic products: types of inspection documents (2004 edition, current).
The four types
Type 2.1, declaration of compliance with the order: the manufacturer states that the products comply with the order, with no test results.
Type 2.2, test report: the manufacturer states compliance and gives test results from non-specific inspection, that is, results from production of the same kind but not necessarily from the delivered items.
Type 3.1, inspection certificate: the manufacturer states compliance and gives results of specific inspection and testing on the delivered products (chemical analysis of the heat, mechanical tests on the batch), validated by the manufacturer's authorised inspection representative who is independent of the manufacturing department.
Type 3.2, inspection certificate: as 3.1, but validated jointly by the manufacturer's representative and either the purchaser's authorised representative or an inspector designated by official regulations (a third-party inspection body).
What each proves, and which to ask for
A 3.1 ties the delivered material to a heat number with measured properties and is the usual requirement for pressure-retaining parts under ASME, PED and B31.3. A 3.2 adds independent witness and is asked for on critical items, sour-service materials and where a client's inspection agency is involved. Traceability is the practical burden: the heat number on the certificate must be transferable to the cut piece, the weld map and the data book, and material certified in one standard (EN) may need its properties checked against another (ASME Section II).
What it means for our equipment
Pressure-retaining materials in our reactors, vessels, skids and sampling systems are supplied with 3.1 certificates by default, with 3.2 on request, and wetted parts in sour service carry certificates that state the NACE MR0175 / ISO 15156 condition; the data book cross-references heat numbers to drawings. See ASME Section VIII, PED and NACE MR0175. All our standards guides.
Send your application, materials and the standards your contract names to mail@techincresearch.com or call +1 (289) 622-1032, and we will return a configuration, datasheet and quotation.
This article is our commentary on the standard's published scope, not a substitute for the standard itself; always work to the current edition named in your contract. Equipment specifications may change; performance depends on the application, how the equipment is used and operation in line with the operation manual.
Sources
LRQA, EN 10204 Type 3.2 factsheet, overview.
Projectmaterials, EN 10204 certificate types 2.1, 2.2, 3.1 and 3.2, overview article.





Comments