top of page

Control Valve Cv and Kv Sizing Calculator for Liquid and Gas (IEC 60534 / ISA-75 Equations)

Writer: Tech Inc
Tech Inc
4 minutes ago
2 min read

A control valve is sized by its flow coefficient, and the equations that connect flow, pressure drop and Cv are standardised in IEC 60534-2-1 (ISA-75.01). This calculator applies the basic forms for liquids and gases so a valve can be checked before the maker's sizing program is run.

How it works

  • Liquid: Cv = Q √(G ÷ ΔP) with Q in US gpm and ΔP in psi; choked flow when ΔP exceeds F_L² (P₁ − F_F P_v), in which case the choked drop is used and cavitation or flashing is flagged.

  • Gas: Cv = Q ÷ (1360 P₁ Y) √(G_g T Z ÷ x) with Q in scfh, P₁ in psia, T in °R, x = ΔP/P₁ limited to F_k x_T, and the expansion factor Y = 1 − x ÷ (3 F_k x_T).

  • Kv = 0.865 Cv. If you enter a candidate valve's rated Cv, the calculator reports the percentage of rated Cv at the duty and flags the usual 20 to 80% control range.

Worked example

20 m³/h of water from 8 to 5 bar(g) through a globe valve (F_L 0.9): 88 US gpm and 43.5 psi give a required Cv of 13.4 (Kv 11.6); the choked drop is 106 psi, far above the actual drop, so no cavitation concern. A valve rated Cv 50 would run at 27% open, a good position for control.

Limits

The piping geometry factor F_P (reducers at the valve), the Reynolds number factor for viscous or very small flows, noise prediction (IEC 60534-8) and the cavitation index are not included, and F_F uses the critical pressure of water. The valve maker's program with the tested coefficients for the specific valve and trim is the final sizing. Our pressure reducing and metering stations, fuel gas conditioning skids and sample conditioning systems carry control and letdown valves sized this way; the IEC 60534 guide explains the standard. All Tech Inc. calculators and converters.

Write to mail@techincresearch.com or call +1 (289) 622-1032.

Disclaimer: this calculator and article give estimates from simplified, published equations and the values you enter, for general information only and without warranty. They are not engineering, design, safety or regulatory advice and are no substitute for measurement, the equipment or chemical maker's instructions, the applicable standards or the judgement of a qualified engineer. Do not rely on them for safety-critical decisions. Tech Inc. accepts no liability for loss, damage or injury arising from their use. Equipment specifications are typical and may change; results depend on the fluids and conditions, how the equipment is used and operation in line with the operation manual. See our product information disclaimer and terms of use.

Sources

Comments


bottom of page