Triaxial Test Mohr–Coulomb Calculator: Cohesion, Friction Angle and UCS from Confined Strengths

Three triaxial tests become two parameters, cohesion and friction angle, which then feed every wellbore stability, caprock integrity and hydraulic fracturing model. This calculator does the fit and reports how well the straight line holds.
How it works
Terzaghi effective stress σ′ = σ − pore pressure applied to both σ₁ and σ₃.
Least-squares fit of σ′₁ = N_φ σ′₃ + 2c√N_φ where N_φ = tan²(45° + φ/2); the slope gives φ, the intercept gives c and the unconfined compressive strength (σ₃ = 0).
Envelope in shear terms τ = c + σ′ tan φ; failure plane at 45° + φ/2 to the σ₃ direction; R² when three or more points are entered.
Worked example
Peak strengths of 85, 125 and 160 MPa at 5, 15 and 25 MPa confinement: slope 3.75, friction angle 35.4°, cohesion 17.3 MPa, UCS 67 MPa (9,730 psi) and R² 0.998, a linear envelope over this range. The failure plane sits at 62.7° to the confining direction.
Limits
Rock envelopes curve at high confinement; if R² falls below 0.95 a Hoek–Brown fit is more faithful. Two tests give an exact line with no check. Strain rate, saturation and temperature all move the parameters, so test at the conditions the model will use. Our triaxial rock mechanics systems, acoustic velocity core systems and CO₂ and hydrogen storage core test systems produce these data; see the CO₂ and hydrogen storage caprock testing note. All Tech Inc. calculators and converters.
Related tools: Core permeability and porosity, Pressure units (gauge/absolute), Membrane tensile test, Permeability units. All 57 calculators and converters.
Write to mail@techincresearch.com or call +1 (289) 622-1032.
Disclaimer: this calculator and article give estimates from simplified, published equations and the values you enter, for general information only and without warranty. They are not engineering, design, safety or regulatory advice and are no substitute for measurement, the equipment or chemical maker's instructions, the applicable standards or the judgement of a qualified engineer. Do not rely on them for safety-critical decisions. Tech Inc. accepts no liability for loss, damage or injury arising from their use. Equipment specifications are typical and may change; results depend on the fluids and conditions, how the equipment is used and operation in line with the operation manual. See our product information disclaimer and terms of use.





Comments