Membrane Tensile Test Calculator: Strength, Elongation at Break and Modulus

A tensile test on a membrane strip gives force and extension. Strength, elongation and modulus need the specimen dimensions, and this calculator applies them.
How it works
Tensile strength = maximum force ÷ original cross-section (width × thickness).
Elongation at break = extension at break ÷ gauge length × 100.
Young's modulus = (Δforce ÷ area) ÷ (Δextension ÷ gauge length) between two points on the initial linear part of the curve.
Worked example
A 10 mm × 120 µm strip, 50 mm gauge length, 12 N maximum, 15 mm at break: strength 10 MPa, elongation 30%. Points (2 N, 0.5 mm) and (4 N, 1.0 mm) give a modulus of 167 MPa.
Limits
ASTM D882 specifies specimen size, grip separation and speed by thickness, and measures thickness to 0.0025 mm; our commentary is in ASTM D882 explained. Wet membranes should be tested wet and quickly. Our tensile strength tester and tensile testing service report these values. All Tech Inc. calculators and converters.
Related tools: Surface free energy (OWRK), Porosity and tortuosity, Triaxial Mohr–Coulomb, Module area. All 57 calculators and converters.
Write to mail@techincresearch.com or call +1 (289) 622-1032.
Disclaimer: this calculator and article give estimates from simplified, published equations and the values you enter, for general information only and without warranty. They are not engineering, design, safety or regulatory advice and are no substitute for measurement, the equipment or chemical maker's instructions, the applicable standards or the judgement of a qualified engineer. Do not rely on them for safety-critical decisions. Tech Inc. accepts no liability for loss, damage or injury arising from their use. Equipment specifications are typical and may change; results depend on the membranes and conditions, how the equipment is used and operation in line with the operation manual. See our product information disclaimer and terms of use.
Sources
ASTM International, ASTM D882-26a Standard Test Method for Tensile Properties of Thin Plastic Sheeting.





Comments