Surface Free Energy Calculator (OWRK) from Two Contact Angles

A single water contact angle says whether a surface is hydrophilic. Two contact angles with different liquids give the surface free energy and split it into dispersive and polar parts, which is what adhesion and fouling studies need.
How it works
OWRK: γL(1 + cos θ) ÷ 2 = √(γs^d γL^d) + √(γs^p γL^p). With two liquids of known components this is two equations in two unknowns, solved exactly. Liquid data (mN/m, total; dispersive; polar): water 72.8; 21.8; 51.0. Diiodomethane 50.8; 50.8; 0. Ethylene glycol 48.0; 29.0; 19.0. Glycerol 63.4; 37.0; 26.4. Formamide 58.0; 39.0; 19.0.
Worked example
Water 65°, diiodomethane 40°: dispersive 39.6, polar 9.8, total 49.5 mN/m, polarity 20%.
Limits
Use one polar and one non-polar liquid, measured on a dry, flat, clean sample with sessile drops of equal volume. Rough or porous membranes give apparent angles; report the method. Our contact angle instruments and contact angle testing service measure both liquids. All Tech Inc. calculators and converters.
Related tools: Membrane tensile test, BET surface area, Porosity and tortuosity, Bubble point and pore size. All 57 calculators and converters.
Write to mail@techincresearch.com or call +1 (289) 622-1032.
Disclaimer: this calculator and article give estimates from simplified, published equations and the values you enter, for general information only and without warranty. They are not engineering, design, safety or regulatory advice and are no substitute for measurement, the equipment or chemical maker's instructions, the applicable standards or the judgement of a qualified engineer. Do not rely on them for safety-critical decisions. Tech Inc. accepts no liability for loss, damage or injury arising from their use. Equipment specifications are typical and may change; results depend on the membranes and conditions, how the equipment is used and operation in line with the operation manual. See our product information disclaimer and terms of use.
Sources
Prof Steven Abbott, Surface Energy Calculator help.





Comments