Membrane Porosity, Tortuosity and Mean Pore Radius Calculator

Porosity, tortuosity and mean pore radius appear in almost every membrane fabrication paper, usually from the same three measurements. This calculator does the arithmetic.
How it works
Porosity ε = (m_wet − m_dry) ÷ (ρ_liquid × A × l): the pore volume filled by the wetting liquid over the sample volume.
Tortuosity τ = (2 − ε)² ÷ ε (Mackie–Meares).
Mean pore radius (Guerout–Elford–Ferry): r = √[(2.9 − 1.75ε) × 8μlQ ÷ (ε × A × ΔP)], from the pure water flow Q at pressure ΔP.
Worked example
Wet 0.30 g, dry 0.18 g, 12.5 cm², 150 µm thick, water: ε = 64%, τ = 2.9. With 20 mL/min at 1 bar and 25 °C the mean pore radius is about 38 nm.
Limits
Blot the surface consistently; the wet mass is the largest error. The GEF radius assumes straight cylindrical pores, so it is a comparative figure. For a measured pore size distribution use capillary flow porometry or our porometry testing service; see also how to measure membrane porosity. All Tech Inc. calculators and converters.
Related tools: Hagen–Poiseuille pore flux, Bubble point and pore size, BET surface area, MWCO to pore size. All 57 calculators and converters.
Write to mail@techincresearch.com or call +1 (289) 622-1032.
Disclaimer: this calculator and article give estimates from simplified, published equations and the values you enter, for general information only and without warranty. They are not engineering, design, safety or regulatory advice and are no substitute for measurement, the equipment or chemical maker's instructions, the applicable standards or the judgement of a qualified engineer. Do not rely on them for safety-critical decisions. Tech Inc. accepts no liability for loss, damage or injury arising from their use. Equipment specifications are typical and may change; results depend on the membranes and conditions, how the equipment is used and operation in line with the operation manual. See our product information disclaimer and terms of use.
Sources
Angewandte Chemie International Edition (2018), Belfort, Membrane Filtration with Liquids, via OSTI.
chemeurope.com encyclopedia, Temperature dependence of liquid viscosity.





Comments