BET Surface Area Calculator: Multipoint BET from Isotherm Points, C Constant and Skeletal Density

A BET number without its C constant and fit range is a number without a pedigree. This calculator does the multipoint BET fit from your raw isotherm points, reports the checks that make it defensible, and adds the skeletal density from a gas pycnometer.
How it works
BET line: 1 ÷ [Q (p₀/p − 1)] against p/p₀; slope s and intercept i give the monolayer capacity Q_m = 1 ÷ (s + i) and C = 1 + s/i.
Surface area = Q_m × N_A × σ ÷ 22,414, with σ = 0.162 nm² for nitrogen at 77 K (argon, krypton and CO₂ options included).
Rouquerol consistency: Q(1 − p/p₀) must increase across the chosen points and C must be positive.
Pycnometer: V_sample = V_cell − V_expansion ÷ (P₁/P₂ − 1); density = mass ÷ volume; open porosity against the envelope volume.
Worked example
Five points from p/p₀ 0.05 to 0.25 (44.2 to 64.7 cm³/g STP) give slope 0.0198, intercept 1.99 × 10⁻⁴, Q_m 50.0 cm³/g, C = 101, R² = 1.000 and 218 m²/g, with the Rouquerol check passing. A 2.5 g sample in a 10 cm³ cell with 8 cm³ expansion volume, 134.5 kPa falling to 71.2 kPa, has a skeletal volume of 1.00 cm³ and density 2.50 g/cm³; against a 1.6 cm³ envelope volume that is 37% open porosity.
Limits
For microporous materials (zeolites, activated carbons, MOFs) the BET range moves to lower p/p₀ and the area is a comparative, not a geometric, value; report the range and C. Outgassing conditions change results, so state them. Our BET surface area analysers, gas pycnometers and chemisorption analysers are in the surface area and density analysers range. All Tech Inc. calculators and converters.
Related tools: Breakthrough capacity, Porosity and tortuosity, Core permeability and porosity, Surface free energy (OWRK). All 57 calculators and converters.
Write to mail@techincresearch.com or call +1 (289) 622-1032.
Disclaimer: this calculator and article give estimates from simplified, published equations and the values you enter, for general information only and without warranty. They are not engineering, design, safety or regulatory advice and are no substitute for measurement, the equipment or chemical maker's instructions, the applicable standards or the judgement of a qualified engineer. Do not rely on them for safety-critical decisions. Tech Inc. accepts no liability for loss, damage or injury arising from their use. Equipment specifications are typical and may change; results depend on the fluids and conditions, how the equipment is used and operation in line with the operation manual. See our product information disclaimer and terms of use.
Sources
IUPAC, Thommes et al., Pure and Applied Chemistry 87 (2015) 1051, Physisorption of gases, with special reference to the evaluation of surface area and pore size distribution (IUPAC Technical Report).
ISO, ISO 9277 Determination of the specific surface area of solids by gas adsorption: BET method.
Wikipedia, BET theory.





Comments