Core Permeability and Porosity Calculator: Darcy's Law, Klinkenberg Correction and Helium Porosity

Routine core analysis reduces to two measurements, how fast gas flows through the plug and how much gas the pore space holds. This calculator does the arithmetic for both, including the slip correction that separates gas permeability from the liquid-equivalent value.
How it works
Gas permeability from Darcy's law for compressible flow: k = 2 μ L Q_out P_out ÷ [A (P_in² − P_out²)], absolute pressures, flow measured at the outlet pressure.
Klinkenberg: k_gas = k_∞ (1 + b ÷ P_mean); two measurements at different mean pressures give k_∞ (the liquid permeability) and the slip factor b.
Liquid permeability from the incompressible form k = μ L Q ÷ (A ΔP).
Boyle's-law porosimeter: P₁ V_ref = P₂ (V_ref + V_chamber − V_grain) gives grain volume; porosity = (bulk − grain) ÷ bulk; grain density from the dry mass.
Worked example
A 38.1 × 50.8 mm plug passing 20 cm³/min of nitrogen at 1.0 bar(g) inlet to atmosphere: 1.79 mD at a mean pressure of 1.49 atm. A second point, 45 cm³/min at 2.0 bar(g), gives 1.52 mD at 1.99 atm; the Klinkenberg line gives k_∞ = 0.68 mD with b = 2.45 atm, a tight rock with strong slip. The porosimeter expansion from 6.9 to 3.71 bar(g) gives a grain volume of 46.2 cm³, 20.2% porosity and a grain density of 2.65 g/cm³, quartz-like.
Limits
Keep the confining stress and the back pressure recorded; permeability of tight rock falls with net stress. Turbulence (Forchheimer) at high flow lowers apparent permeability in the other direction from slip, so use low flows. Overburden and reservoir-condition measurements need a core flooding system. Our multi-sample core porosimeter and permeameter, core flooding systems, relative permeability systems and core holders are in the core analysis instruments range; the permeability unit converter handles the units. All Tech Inc. calculators and converters.
Related tools: Permeability units, Triaxial Mohr–Coulomb, BET surface area, Hagen–Poiseuille pore flux. All 57 calculators and converters.
Write to mail@techincresearch.com or call +1 (289) 622-1032.
Disclaimer: this calculator and article give estimates from simplified, published equations and the values you enter, for general information only and without warranty. They are not engineering, design, safety or regulatory advice and are no substitute for measurement, the equipment or chemical maker's instructions, the applicable standards or the judgement of a qualified engineer. Do not rely on them for safety-critical decisions. Tech Inc. accepts no liability for loss, damage or injury arising from their use. Equipment specifications are typical and may change; results depend on the fluids and conditions, how the equipment is used and operation in line with the operation manual. See our product information disclaimer and terms of use.
Sources
SPE PetroWiki, Permeability determination and Klinkenberg effect.
SPE PetroWiki, Porosity determination.





Comments