top of page

Application Note: Laboratory Tests for CO2 and Hydrogen Storage

Writer: Tech Inc
Tech Inc
5 days ago
2 min read

At a glance. Before CO2 or hydrogen is stored underground, laboratory tests show whether the caprock will seal and how the reservoir rock will behave. The core questions are the same for both gases: how tight is the caprock, at what pressure will gas break through it, how does reaction with brine change the rock, and, for hydrogen, what repeated injection and withdrawal does.

Caprock permeability

Caprocks are so tight that steady flow takes too long to measure. The pulse-decay method, introduced by Brace and co-workers for very low-permeability rock, applies a small pressure step across the sample and measures how quickly it decays, reaching into the nanodarcy range.

Breakthrough pressure

Gas pressure is raised in steps against a brine-saturated caprock sample until gas breaks through. The capillary entry pressure sets the column height of gas the seal can hold.

Reaction with brine and rock

Dissolved CO2 forms a weak acid that can dissolve or precipitate minerals, changing permeability over time. Tests hold rock, brine and CO2 at reservoir conditions and track permeability and effluent chemistry.

Hydrogen cycling

Hydrogen storage, unlike CO2 storage, is cyclic: gas is injected and withdrawn with the seasons. The research challenges, from flow and trapping to microbial activity, are summarised by Heinemann and co-authors; laboratory rigs repeat injection and withdrawal at pressure and track how permeability and saturation change.

The equipment

A tri-axial core holder in titanium or nickel alloy, gas and brine pumps, a pulse-decay module, sensitive flow detection for breakthrough and, for hydrogen, detection, ventilation and venting to a safe location.

Where Tech Inc. equipment fits

Related reading

Sources

This note is general information. Test programmes follow each project's study plan and regulator requirements.

Comments


bottom of page