Gas Hydrate Formation Temperature and Methanol/MEG Inhibitor Dosing Calculator

Hydrates block sample lines, chokes and pipelines whenever wet gas is cold enough at pressure. This calculator gives the hydrate temperature for your gas, the subcooling you are exposed to, and the inhibitor that removes it.
How it works
Hydrate temperature from the Towler and Mokhatab correlation, a fit to the Katz gas-gravity chart: T(°F) = 13.47 ln P + 34.27 ln γ − 1.675 ln P ln γ − 20.35, with P in psia and γ the gas gravity.
Subcooling = hydrate temperature − line temperature; a design margin is added.
Hammerschmidt: ΔT = K W ÷ [M (100 − W)], solved for the inhibitor weight fraction W in the aqueous phase with K = 2335 and the inhibitor molecular weight M; the neat and as-supplied injection rates follow from the water rate.
Worked example
A 0.65-gravity gas at 60 bar(g) forms hydrates at 16 °C. At a 5 °C line temperature the subcooling is 11 °C; with a 2 °C margin, MEG at 26 wt% in the aqueous phase is needed, which for 50 kg/h of water is 17.6 kg/h of neat glycol or 22 kg/h of 80% solution, about 0.47 m³/day.
Limits
The gravity chart is for sweet gas; H₂S and CO₂ raise the hydrate temperature and need a composition-based prediction. Hammerschmidt is a screening equation, conservative for glycols and optimistic for methanol above about 25 wt%; methanol lost to the vapour and liquid hydrocarbon phases must be added. The robust alternatives are drying the gas or heating the sample line. Our gas dehydration skids, chemical injection skids, heated sample probes and gas sampling panels address all three routes; the dew point converter gives the water content that drives the problem. All Tech Inc. calculators and converters.
Related tools: Dew point and moisture, Chemical injection dosing, Gas flow units, RVP to TVP. All 63 calculators and converters.
Write to mail@techincresearch.com or call +1 (289) 622-1032.
Disclaimer: this calculator and article give estimates from simplified, published equations and the values you enter, for general information only and without warranty. They are not engineering, design, safety or regulatory advice and are no substitute for measurement, the equipment or chemical maker's instructions, the applicable standards or the judgement of a qualified engineer. Do not rely on them for safety-critical decisions. Tech Inc. accepts no liability for loss, damage or injury arising from their use. Equipment specifications are typical and may change; results depend on the fluids and conditions, how the equipment is used and operation in line with the operation manual. See our product information disclaimer and terms of use.
Sources
Towler, B. F. and Mokhatab, S., Hydrocarbon Processing, April 2005, via PetroWiki: Hydrate formation prediction (SPE).
Hammerschmidt, E. G., Industrial & Engineering Chemistry 26 (1934) 851, via Wikipedia: Clathrate hydrate inhibition.





Comments