Water and Salt Permeability Coefficient Calculator (A and B) for RO and NF

A and B are the two numbers that describe an RO or NF membrane in the solution-diffusion model. A is the water permeability, B the salt permeability. This calculator finds both from a bench test.
How it works
Water flux: J = A (ΔP − Δπ), so A = J ÷ (ΔP − Δπ).
Salt flux: Js = B (Cm − Cp) and Js = J × Cp, so B = J × Cp ÷ (Cm − Cp).
Δπ is the osmotic pressure difference between the membrane surface and the permeate, by van 't Hoff for NaCl. Enter a concentration polarisation factor if you know it; see the concentration polarisation calculator.
Worked example
40 LMH at 15.5 bar with 2,000 mg/L feed and 40 mg/L permeate at 25 °C: Δπ = 1.66 bar, A = 2.9 LMH/bar, B = 0.82 LMH, rejection 98%.
Limits
Valid for dilute single-salt feeds and a membrane far from its compaction limit. Report A and B with the temperature; both rise with it. Normalise plant data with the ASTM D4516 calculator. Our lab RO skids log flux, pressure and conductivity for this calculation. All Tech Inc. calculators and converters.
Related tools: Osmotic pressure, RO recovery and rejection, Concentration polarisation, Membrane flux and permeability. All 57 calculators and converters.
Write to mail@techincresearch.com or call +1 (289) 622-1032.
Disclaimer: this calculator and article give estimates from simplified, published equations and the values you enter, for general information only and without warranty. They are not engineering, design, safety or regulatory advice and are no substitute for measurement, the equipment or chemical maker's instructions, the applicable standards or the judgement of a qualified engineer. Do not rely on them for safety-critical decisions. Tech Inc. accepts no liability for loss, damage or injury arising from their use. Equipment specifications are typical and may change; results depend on the membranes and conditions, how the equipment is used and operation in line with the operation manual. See our product information disclaimer and terms of use.
Sources
MANN+HUMMEL Water, TB-018 Reverse Osmosis and Nanofiltration Performance and Design Calculations.
ASTM International, ASTM D4516-19a Standard Practice for Standardizing Reverse Osmosis Performance Data.





Comments