Osmotic Pressure Calculator for RO Feed, Concentrate and Draw Solutions

This calculator estimates the osmotic pressure of a salt or sugar solution with the van 't Hoff equation. Use it to size the pressure for an RO test, to check the osmotic pressure of a concentrate, or to set the strength of a forward osmosis draw solution.
How it works
Π = i × M × R × T
i, the van 't Hoff factor: ions per formula unit (2 for sodium chloride, 3 for calcium chloride, 1 for sugars).
M, molar concentration in mol/L, worked out from your concentration and the molar mass.
R, the gas constant, 8.314 J/(mol·K).
T, absolute temperature in kelvin.
Choose a solute to fill in i and the molar mass, or enter your own.
Worked example
2,000 mg/L sodium chloride at 25 °C gives 0.0342 mol/L and an osmotic pressure of 1.70 bar (24.6 psi). At 35 g/L, the same salt gives about 29.7 bar.
Limits
The equation assumes an ideal solution, so it becomes an estimate at seawater strength and above. Mixed waters need the sum of each ion's contribution. For the full method, see our guide to osmotic pressure calculations.
Equipment
Our lab-scale RO test skids, high-pressure multi-cell systems and FO test skid are built for these pressures. All membrane calculators and converters.
Related tools: RO recovery and rejection, Conductivity to TDS, Water and salt permeability (A, B), Forward osmosis flux. All 57 calculators and converters.
Write to mail@techincresearch.com or call +1 (289) 622-1032.
Disclaimer: this calculator and article give estimates from simplified, published equations and the values you enter, for general information only and without warranty. They are not engineering, design, safety or regulatory advice and are no substitute for measurement, the equipment or chemical maker's instructions, the applicable standards or the judgement of a qualified engineer. Do not rely on them for safety-critical decisions. Tech Inc. accepts no liability for loss, damage or injury arising from their use. Equipment specifications are typical and may change; results depend on the membranes and conditions, how the equipment is used and operation in line with the operation manual.
Sources
Chemistry LibreTexts, 17.7: Osmotic Pressure.





Comments