top of page

Water Hardness Unit Converter: mg/L as CaCO₃, meq/L, °dH, °fH, °Clark and Grains per Gallon

Writer: Tech Inc
Tech Inc
1 day ago
2 min read

Softener catalogues use grains per gallon, European analyses use °dH or °fH, membrane projections use mg/L as CaCO₃ and chemists use meq/L. This converter puts one figure into all of them and builds hardness from a calcium and magnesium analysis.

How it works

Every unit is a multiple of mg/L as CaCO₃: 1 meq/L = 50.04, 1 °dH = 17.85, 1 °fH = 10, 1 °Clark = 14.25, 1 gpg = 17.12. From analysis, hardness = 2.497 × Ca + 4.118 × Mg in mg/L. Classification follows the USGS bands: soft below 60, moderately hard to 120, hard to 180, very hard above.

Worked example

150 mg/L as CaCO₃ is 3.0 meq/L, 8.4 °dH, 15 °fH, 10.5 °Clark and 8.8 gpg: hard water, and a scaling check with pH and alkalinity is due before RO.

Limits

Hardness alone does not predict scaling; the Langelier or Stiff–Davis index needs pH, alkalinity, TDS and temperature, and sulphate and silica have their own limits. For softener and RO pretreatment sizing, our ion exchange columns and SDI analysers cover the two sides of the feed-water question; the ion exchange bed volume calculator uses this load directly. All Tech Inc. calculators and converters.

Write to mail@techincresearch.com or call +1 (289) 622-1032.

Disclaimer: this calculator and article give estimates from simplified, published equations and the values you enter, for general information only and without warranty. They are not engineering, design, safety or regulatory advice and are no substitute for measurement, the equipment or chemical maker's instructions, the applicable standards or the judgement of a qualified engineer. Do not rely on them for safety-critical decisions. Tech Inc. accepts no liability for loss, damage or injury arising from their use. Equipment specifications are typical and may change; results depend on the fluids and conditions, how the equipment is used and operation in line with the operation manual. See our product information disclaimer and terms of use.

Sources

Comments


bottom of page