Ion Exchange Bed Volume Calculator: Resin Volume, BV/h, Run Length and Regenerant per Cycle

Softening, demineralisation and metal recovery columns are all sized the same way: a service rate in bed volumes per hour, an ionic load and an operating capacity. This calculator connects them and shows what a regeneration cycle costs in chemical and water.
How it works
Resin volume = service flow ÷ design BV/h; specific flow also shown in gpm/ft³.
Ionic load converted to meq/L (50.04 mg/L as CaCO₃ per meq/L, or mg/L ÷ equivalent weight).
Capacity per cycle = operating capacity × resin volume; water treated = capacity ÷ load; run length = water ÷ flow.
Regenerant = dose (g per L resin as 100%) × resin volume, then as a solution of the stated strength; rinse in bed volumes.
Worked example
20 m³/h at 16 BV/h needs 1.25 m³ of resin. With 150 mg/L as CaCO₃ (3.0 meq/L) and 1.2 eq/L operating capacity the column treats 500 m³ per cycle, 25 hours, and regenerates with 188 kg of salt (1,875 kg of 10% brine) plus 7.5 m³ of rinse; waste is 1.9% of the water treated.
Limits
Operating capacity depends on regeneration level, flow, temperature and the ions present (sodium leakage, sulphate loading, organics); take it from the resin maker's curves or a column test, not from the total capacity. Co-flow and counter-flow regeneration differ in dose and leakage. Our ion exchange metal recovery columns, nuclear waste ion exchange skids and resin purification skids are built from these numbers; the water hardness unit converter handles the load units. All Tech Inc. calculators and converters.
Related tools: Water hardness units, Leach pulp density, Electrowinning, Conductivity to TDS. All 57 calculators and converters.
Write to mail@techincresearch.com or call +1 (289) 622-1032.
Disclaimer: this calculator and article give estimates from simplified, published equations and the values you enter, for general information only and without warranty. They are not engineering, design, safety or regulatory advice and are no substitute for measurement, the equipment or chemical maker's instructions, the applicable standards or the judgement of a qualified engineer. Do not rely on them for safety-critical decisions. Tech Inc. accepts no liability for loss, damage or injury arising from their use. Equipment specifications are typical and may change; results depend on the fluids and conditions, how the equipment is used and operation in line with the operation manual. See our product information disclaimer and terms of use.
Sources
Wikipedia, Ion-exchange resin.
Lenntech, Ion exchange: resin capacity, bed volumes and regeneration (background on operating capacity and BV).





Comments