top of page

Leach Slurry Pulp Density Calculator: Percent Solids, Slurry Flow, Reagent and Residence Time

Writer: Tech Inc
Tech Inc
1 day ago
2 min read

Leaching runs on slurry, and slurry is specified three ways: percent solids by mass, pulp specific gravity and percent solids by volume. This calculator converts between them and gives the flows, reagent and residence time that size the tanks.

How it works

  • Percent solids from a measured pulp SG: C_w = (SG_pulp − SG_liquor) ÷ (SG_solids − SG_liquor) × SG_solids ÷ SG_pulp.

  • Liquor mass = solids × (1 − C_w) ÷ C_w; slurry volume = solids ÷ SG_solids + liquor ÷ SG_liquor; pulp density = total mass ÷ volume.

  • Reagent as 100% = dose × solids; as supplied = ÷ strength; volume from the reagent SG.

  • Residence time = live tank volume ÷ (slurry + reagent flow).

Worked example

50 t/h of ore (SG 2.7) at 40% solids in a 1.05 SG liquor: 75 t/h of liquor, 90 m³/h of slurry at pulp SG 1.39, 20.6% solids by volume. At 25 kg/t of acid supplied as 98% (SG 1.84) the plant uses 1.28 t/h, 693 L/h, and 1,200 m³ of live tank volume gives 13.2 hours of residence.

Limits

Reagent consumption is a test result from bottle rolls or a pilot autoclave, not a design assumption; include the acid consumed by gangue. Residence time is the mean; the distribution across a train of tanks sets extraction, and short-circuiting lowers it. Above about 60% solids most slurries cannot be agitated or pumped for leaching. Our pressure leach autoclaves, leach filtration trains and caustic fusion reactors are in the battery recycling and hydrometallurgy range. All Tech Inc. calculators and converters.

Write to mail@techincresearch.com or call +1 (289) 622-1032.

Disclaimer: this calculator and article give estimates from simplified, published equations and the values you enter, for general information only and without warranty. They are not engineering, design, safety or regulatory advice and are no substitute for measurement, the equipment or chemical maker's instructions, the applicable standards or the judgement of a qualified engineer. Do not rely on them for safety-critical decisions. Tech Inc. accepts no liability for loss, damage or injury arising from their use. Equipment specifications are typical and may change; results depend on the fluids and conditions, how the equipment is used and operation in line with the operation manual. See our product information disclaimer and terms of use.

Sources

Comments


bottom of page