top of page

Cross-Flow Velocity Calculator: Reynolds Number and Wall Shear Rate

Writer: Tech Inc
Tech Inc
1 day ago
2 min read

Cross-flow velocity sets concentration polarisation and fouling, so it has to be reported with every membrane result. This calculator converts a pump flow into velocity, Reynolds number and wall shear for the three common channel shapes.

How it works

  • Velocity v = Q ÷ (flow area). For a spacer-filled channel the area is reduced by the spacer void fraction.

  • Hydraulic diameter: 2wh ÷ (w + h) for an empty slit; 4ε ÷ [2/h + (1 − ε)Sv] with a spacer; the inner diameter for tubes.

  • Re = ρ v dh ÷ μ. Wall shear rate 6v/h (slit) or 8v/d (tube).

Worked example

2 L/min through a 40 mm × 2 mm empty channel at 25 °C: 0.42 m/s, dh 3.8 mm, Re 1,780 (laminar), shear rate 1,250 s⁻¹.

Limits

Spacer correlations differ between makers; the flow regime in a spacer channel becomes unsteady well below Re 2,100. Water properties are used; viscous feeds lower Re. Our crossflow test cells, large cells and testing systems state their channel dimensions so you can use this tool directly. All Tech Inc. calculators and converters.

Write to mail@techincresearch.com or call +1 (289) 622-1032.

Disclaimer: this calculator and article give estimates from simplified, published equations and the values you enter, for general information only and without warranty. They are not engineering, design, safety or regulatory advice and are no substitute for measurement, the equipment or chemical maker's instructions, the applicable standards or the judgement of a qualified engineer. Do not rely on them for safety-critical decisions. Tech Inc. accepts no liability for loss, damage or injury arising from their use. Equipment specifications are typical and may change; results depend on the membranes and conditions, how the equipment is used and operation in line with the operation manual. See our product information disclaimer and terms of use.

Sources

Comments


bottom of page