top of page

ISO 10438 Explained: Lubrication, Shaft-Sealing and Control-Oil Systems for Rotating Machinery (the ISO Twin of API 614)

Writer: Tech Inc
Tech Inc
29 minutes ago
2 min read

ISO 10438-1:2007, Petroleum, petrochemical and natural gas industries — Lubrication, shaft-sealing and control-oil systems and auxiliaries — Part 1: General requirements (edition 2, confirmed 2026) is the international edition of API Standard 614. ISO's abstract says it sets baseline requirements for lubrication systems, oil-type and dry-gas face-type shaft-sealing systems and control-oil systems for general- and special-purpose applications, with general-purpose limited to lubrication systems; it is used with Part 2 (special-purpose oil systems), Part 3 (general-purpose oil systems) or Part 4 (self-acting gas seal support systems), and the systems may serve compressors, gears, pumps and drivers.

What it covers

Reservoirs with retention time and sloped bottoms, duplex pumps with auto-start of the standby, coolers, duplex filters with transfer valves that allow changeover on line, pressure and temperature control, accumulators where the machine needs rundown protection, instrumentation and alarm/trip logic, piping class and cleanliness, and the testing and documentation of the console. The special-purpose parts tighten the requirements (stainless steel piping, redundancy, more instrumentation) for unspared machines.

Our commentary

  • API 614 or ISO 10438? The content is aligned by design; the contract names one, and the datasheet follows that document's numbering. Our API 614 guide covers the API view.

  • Retention time and filtration are the two numbers that most often get cut to save money and most often cause trouble: short retention leaves air and water in the oil, coarse filtration shortens bearing life (ISO 4406 target).

  • Changeover without a trip depends on the transfer valve and the fill-and-vent of the standby filter and cooler; it is a procedure, and the console must be built so the procedure can be followed.

  • Seal support is a separate discipline. Dry gas seal panels (Part 4) condition and meter the seal gas; see our seal gas conditioning skids.

Our equipment

Send your application, materials and the standards your contract names to mail@techincresearch.com or call +1 (289) 622-1032, and we will return a configuration, datasheet and quotation.

This article is our commentary on the standard's published scope, not a substitute for the standard itself; always work to the current edition named in your contract. Equipment specifications may change; performance depends on the application, how the equipment is used and operation in line with the operation manual.

Sources

Comments


bottom of page