Control Oil and Jacking Oil HPU Module

• Control-oil HPU module – supplies the turbine governing and trip valve actuators.
• Jacking-oil HPU module – high-pressure oil lift for turbine-generator bearings at low speed.
• Seal-oil skid sub-assemblies – re-engineered pump, filter and valve assemblies for generator seal-oil systems.
• Fuel-oil skid sub-assemblies – pump and filter assemblies for fuel-oil systems.
• TI-EHU600 – turbine valve-control hydraulic power unit supplying fire-resistant EH oil to the steam valve actuators.
• TI-JOU600 – jacking-oil pump skid that lifts the turbine shaft on an oil film at low speed.

• Design basis: site survey and measured samples of the existing unit, with original data where available
• Pressure and flow: matched to the existing duty, or to client specification
• Fluid: turbine oil or fire-resistant fluid, to client specification
• Filtration: duplex filters for change while running, to the turbine's cleanliness requirement
• Interfaces: footprint, piping and electrical connections matched to the existing installation
• Piping materials: stainless steel or carbon steel, to client specification
• Bought-in equipment: proven pumps and accumulators from leading makers, integrated into a module designed and built by Tech Inc.

The modules serve thermal power plants where the original turbine oil system units are worn, obsolete or slow to source. Control-oil modules supply the turbine governing and trip system, and jacking-oil modules protect the bearings during start-up, shutdown and turning gear. The seal-oil and fuel-oil sub-assemblies replace pump and filter sets in place.

• Drop-in replacement – interchangeable with common OEM designs and matched to existing interfaces.
• No drawings needed – modules engineered from site measurements and samples.
• Filter change on line – duplex housings keep the turbine running during element change.
• Duty and standby pumps – automatic changeover holds oil pressure if a pump trips.
• Short outage – factory-tested modules limit site work to the tie-in.

• Established manufacturer – part of the Davey Group since 1990, exporting to more than 110 countries.
• Everything under one roof – in-house mechanical fabrication, electrical works, PLC and SCADA automation, and R&D.
• Complete scope – design, supply, installation, commissioning, factory acceptance testing (FAT) and site acceptance testing (SAT).
• Trusted by Saudi Aramco – an established supplier to Saudi Aramco.
• Certified management systems – ISO 9001, ISO 14001 and ISO 45001, with CE marking.
• Close to your project – offices in Chennai (India), Toronto (Canada), Tallinn (Estonia) and Al Khobar (Saudi Arabia).
• For this product – reverse engineering, fabrication, flushing and testing of every module carried out in-house before dispatch.

Engineering to your P&ID, data sheets and company standards; drawings submitted for approval before manufacture; factory acceptance testing (FAT) with client or third-party inspection; export packing and full documentation dossier; installation, commissioning and site acceptance testing (SAT); operator training, spares and after-sales support worldwide. Contact mail@techincresearch.com or +1 (289) 622-1032.

• Hydraulic Power Unit (HPU) – the standard HPU range for process and actuator duties.
• Lube Oil Console – turbine and compressor lube oil systems.
• Lube and Control Oil Filter Elements and Duplex Housings – replacement elements and housings for the same oil systems.
• Hydraulic Oil Flushing Unit – flushing of the oil system after module replacement.