UTS and IIT Guwahati Push Membrane Distillation to 90% Recovery, Tracked on the AL-500

At a glance. Membrane distillation can treat brines that reverse osmosis cannot, but the closer you push it to full recovery, the faster the membrane fouls. A team from the University of Technology Sydney and IIT Guwahati ran air gap membrane distillation at 80, 85 and 90 per cent recovery on real seawater and landfill leachate, and used the Tech Inc. AL-500 capillary flow porometer to see what fouling did to the pores.
Why this matters
Higher recovery means less brine to dispose of, which is the main cost and environmental problem in desalination and wastewater reuse. The question is how much fouling a membrane distillation system can tolerate at high recovery, and whether it can be cleaned back to full performance.
What the team did
Abdulaziz Khan and colleagues at UTS, working with NYU Abu Dhabi, Al-Mustaqbal University and IIT Guwahati, ran air gap membrane distillation with PTFE membranes on real seawater and landfill leachate at three recoveries and two feed temperatures, 55 and 65 °C. They then analysed the foulant layers and tested cleaning with deionised water and with hydrogen peroxide.
Where Tech Inc. came in
Telling pore blocking from surface cake is the heart of a fouling study. The team measured the pore sizes of clean and fouled PTFE membranes on the Tech Inc. AL-500 capillary flow porometer. A shift in pore size distribution shows foulant inside the pores; an unchanged distribution with a flux drop points to a cake on the surface. That evidence is what let them conclude that seawater fouling blocked pores while leachate formed a porous surface layer.
Results that stand out
Raising the feed from 55 to 65 °C cut operating time by 42.8% at every recovery.
At 65 °C, average flux was 32% to 37% higher than at 55 °C.
Flux decline was worst at 90% recovery and 65 °C.
Seawater formed a cake of mainly metal oxides; leachate fouling combined pore blocking with a carbon- and nitrogen-rich cake.
Cleaning with hydrogen peroxide restored more than 97% of the water flux.
The fouling factor was 10% for seawater and 16% for wastewater.
What it means for your lab
Any fouling or cleaning study benefits from before-and-after pore size data. Our porometers measure through-pore size from nanometres to hundreds of microns, and our porometry testing service runs the measurement on your samples if you do not have an instrument. For the method itself, see capillary flow porometry compared with mercury porosimetry. The follow-up study from the same group is here.
The paper
Khan, A., Yadav, S., Ibrar, I., Al-Juboori, R. A., Razzak, S. A., Deka, P., Subbiah, S. and Shah, S. (2022). Fouling and performance investigation of membrane distillation at elevated recoveries for seawater desalination and wastewater reclamation. Membranes 12(10), 951. doi:10.3390/membranes12100951
Read the full paper at the publisher for methods, data and figures.
Part of the Research with Tech Inc. series
This post is one of a series on published research made with Tech Inc. equipment and materials. See the full list on Research using Tech Inc. equipment. Next in the series: Tin Sulfide-Coated PTFE Cuts Fouling in Leachate Distillation: a UTS Study with the AL-500.
Published with our equipment? Send the reference to mail@techincresearch.com and we will feature your work. To discuss equipment for a similar study, call +1 (289) 622-1032 or write to mail@techincresearch.com.





Comments