Cyclic Olefin Polymer Membranes for Distillation, Run Long-Term on a Tech Inc. DCMD Rig

At a glance. New membrane polymers are rare. Researchers at Complutense University of Madrid and Ferdowsi University of Mashhad, led by Professor Mohamed Khayet, introduced cyclic olefin polymer as a membrane material for distillation, reaching 99.99 per cent salt separation. Their long-term tests ran on a Tech Inc. direct contact membrane distillation set-up, model FMD-SS-3090.
Why this matters
Membrane distillation relies on a small set of hydrophobic polymers, mainly PTFE, PVDF and PP. Each has drawbacks in cost, processing or chemical resistance. Cyclic olefin polymers are clear, very hydrophobic and resist acids, bases and polar solvents, but had not been made into distillation membranes before.
What the team did
Malihe Sabzekar, Mahdi Pourafshari Chenar, Zahra Maghsoud, O. Mostaghisi, Carmen García-Payo and Mohamed Khayet made flat sheet membranes from cyclic olefin polymer (Zeonex 480R) and copolymer (Topas 6013) by non-solvent induced phase separation, varying solvents, additives and coagulants. They measured contact angle, liquid entry pressure, pore size and porosity, then tested the membranes in direct contact membrane distillation, both in short runs and in long-term runs.
Where Tech Inc. came in
The long-term tests ran on a Tech Inc. direct contact membrane distillation set-up, model FMD-SS-3090, with two Tech Inc. circulation pumps moving feed and permeate at 30 L/h. Long runs are where a new membrane proves itself, and they need a rig that holds temperature and flow steady for days. Our membrane distillation test systems are built for that duty.
Results that stand out
Cyclic olefin polymer formed good membranes; the copolymer did not give a permeable membrane.
Contact angles reached 111°, and liquid entry pressure ranged from 1.16 to 4.55 bar.
The best membrane gave about 20 kg/m²·h with distilled water and 15 kg/m²·h with 30 g/L NaCl, with a 99.99% salt separation factor.
Membranes made with PEG additive were the most stable in 24 to 50 hour tests, holding separation above 99.4% for 50 hours.
The authors conclude that cyclic olefin polymer is a promising new material for membrane distillation.
What it means for your lab
If you are developing distillation membranes, the long-term run is the test that matters. We build lab MD skids and full systems with data acquisition in DCMD, AGMD, SGMD and VMD configurations, with flat sheet test cells to match.
The paper
Sabzekar, M., Pourafshari Chenar, M., Maghsoud, Z., Mostaghisi, O., García-Payo, M. C. and Khayet, M. (2020). Cyclic olefin polymer as a novel membrane material for membrane distillation applications. Journal of Membrane Science 118845. doi:10.1016/j.memsci.2020.118845
Read the full paper at the publisher for methods, data and figures.
Part of the Research with Tech Inc. series
This post is one of a series on published research made with Tech Inc. equipment and materials. See the full list on Research using Tech Inc. equipment. Next in the series: IIT Guwahati Raises Membrane Distillation Efficiency With a Module Co-Developed by Davey Products.
Published with our equipment? Send the reference to mail@techincresearch.com and we will feature your work. To discuss equipment for a similar study, call +1 (289) 622-1032 or write to mail@techincresearch.com.





Comments