top of page

Process Note: Additive Injection at Fuel Loading Terminals

Writer: Tech Inc
Tech Inc
7 hours ago
2 min read

At a glance. Fuel terminals blend small amounts of additives into gasoline, diesel and jet fuel as they load road tankers. Typical additives include detergents and performance packages, lubricity and cetane improvers, static dissipators, corrosion inhibitors, and dyes and markers for tax or brand identification. Doses are small, often measured in parts per million, and must follow the fuel flow closely across each load. Terminals across the world use additive injection skids linked to the loading bay controllers to do this.

How injection works

  1. Storage. Each additive is kept in its own tank, sometimes heated in cold climates.

  2. Pumping and filtering. A pump feeds the additive through a strainer to the injectors.

  3. Metering and control. An injector, usually a meter with a control valve or a positive-displacement piston, adds a set volume of additive for each volume of fuel measured at the bay.

  4. Injection point. The additive enters the fuel line close to the loading arm so that each load receives its full dose.

  5. Monitoring and records. The controller compares the additive delivered with the target for each load and raises an alarm, or stops loading, if the dose is wrong.

Design points

  • Dosing ratio and range for each additive and product.

  • Accuracy at the start and end of a load, where small batches are most sensitive.

  • Additive viscosity and temperature, which change with the weather.

  • Materials compatibility with each additive.

  • Proving and calibration of the injector meters.

  • Integration with the bay controller and the terminal management system, including load records.

  • Fail-safe behaviour when an additive runs out or an injector fails.

Common problems

  • Under- or over-dosing caused by air in the additive line, blocked strainers or leaking check valves.

  • Wrong additive loaded after tank or line mix-ups.

  • Drift when injector meters are not proved regularly.

  • Communication faults between the injection controller and the bay controller.

  • Cold-weather problems with viscous additives.

Where Tech Inc. equipment fits

Related reading

This note is general guidance. Additive types and doses follow the fuel specification, the additive supplier's data and local regulations.

Comments


bottom of page