Process Note: Catalyst and Reaction Screening in Parallel High-Pressure Reactors

At a glance. Catalyst and process development often means testing many catalysts, solvents, temperatures and pressures. A parallel reactor station runs several small high-pressure vessels side by side, each with its own temperature and stirring, so a whole series can be run in the time of one experiment. Pharmaceutical, chemical, petrochemical and academic laboratories across the world use parallel reactors for hydrogenation, oxidation, carbonylation, polymerisation and other pressurised reactions.
The workflow
Plan the series, often as a designed experiment with controls and repeats.
Load catalyst, substrate and solvent into each vessel, in an inert atmosphere where materials are air-sensitive.
Seal and leak-test with inert gas.
Purge the air out with nitrogen, then with the reaction gas.
Heat and pressurise each vessel to its set conditions and start stirring.
Monitor temperature, pressure and, where fitted, gas uptake from a reservoir, which tracks reaction progress.
Sample during the run without depressurising, where the method needs it.
Cool, vent and purge safely before opening.
Analyse the products, usually by GC or HPLC, and compare the vessels.
Design points
Materials: stainless steel for general work, nickel alloys such as Alloy C-276 for acids and halides.
Pressure and temperature ratings for the whole planned range, with relief devices on every vessel.
Independent temperature control for each vessel.
Stirring strong enough that gas–liquid mass transfer does not limit the reaction.
Gas uptake measurement for kinetics.
Safety: small vessel volumes, hydrogen detection, ventilated enclosures and interlocks.
Common problems
Mass transfer limits that hide real differences between catalysts.
Vessel-to-vessel differences in temperature or stirring that look like catalyst effects.
Leaks at seals after repeated opening.
Oxygen left behind after a short purge.
Cross-contamination between runs from poor cleaning.
Where Tech Inc. equipment fits
Tech Inc. supplies the six-vessel parallel reactor station, the benchtop stirred high-pressure reactor in Alloy C-276, the emulsion polymerisation reactor, the closed reactor sampler, the hydrogenation bay kit and the chemisorption analyser for catalyst characterisation. The wider range is on our high-pressure reactors page.
Related reading
This note is general guidance. Reactor operation follows the equipment manual, the laboratory's risk assessment and the chemistry involved.





Comments