top of page

Process Note: SF6 Gas Handling for High-Voltage Switchgear

Writer: Tech Inc
Tech Inc
7 hours ago
2 min read

At a glance. Sulphur hexafluoride (SF6) insulates gas-insulated switchgear (GIS) and quenches the arc in high-voltage circuit breakers. It is also one of the most potent greenhouse gases known, with a global warming potential more than 20,000 times that of CO2, so every kilogram must be kept in the equipment or recovered. Utilities, switchgear makers and service companies across the world use dedicated gas handling equipment to evacuate, fill, recover, clean and store SF6, following IEC 62271-4 and local rules such as the EU F-gas Regulation.

The handling steps

  1. Evacuation of new compartments. Air and moisture are pumped out of a new or opened compartment with a vacuum pump before filling.

  2. Filling. SF6 passes through filters into the compartment up to its rated pressure, corrected for temperature.

  3. Recovery before maintenance. An oil-free compressor draws the gas out through filters and stores it, usually as a liquid in cylinders or a storage tank, until the compartment reaches a low residual pressure.

  4. Purification. Particle filters and molecular sieve or alumina beds remove dust, moisture and decomposition products formed by arcing.

  5. Quality check. The gas is analysed for SF6 content, moisture and decomposition products before reuse. IEC 60480 sets the criteria for reusing SF6; IEC 60376 covers new gas.

  6. Refilling after maintenance, followed by leak checks.

Design points

  • Residual pressure the recovery unit can reach, which sets how much gas is left behind when a compartment is opened.

  • Compressor type: oil-free, so that the gas is not contaminated.

  • Storage: liquid storage in cylinders or tanks, with weighing so that the inventory is known.

  • Couplings and hoses: self-sealing couplings matched to the switchgear, so that connections release no gas.

  • Mobility: carts for substations and trailers for large GIS bays.

  • Record keeping: gas quantities in and out, as many regulations require.

Common problems

  • Gas left in compartments because the recovery unit could not pull a deep enough vacuum.

  • Moisture from poorly evacuated compartments or wet hoses.

  • Saturated filters that let decomposition products back into the switchgear.

  • Leaks at couplings, valves and old seals.

  • Unclear inventory when cylinders are not weighed and logged.

SF6 is not toxic, but it is heavier than air and can displace oxygen in cable trenches and basements. Arcing by-products are toxic and corrosive, so personal protective equipment is used when opening compartments after faults.

Where Tech Inc. equipment fits

Related reading

This note is general guidance. SF6 handling follows the switchgear maker's instructions, IEC 62271-4 and the regulations in force where the work is done.

Comments


bottom of page