top of page

SRM Extracts Acetic Acid with a Tech Inc. PES Hollow Fibre Membrane Contactor

Writer: Tech Inc
Tech Inc
14 hours ago
2 min read

At a glance. Dilute acetic acid turns up in many industrial wastewaters, and separating it from water by distillation is costly. At SRM Institute of Science and Technology, Sofiya Karunanithi and Sivaraman Prabhakar extracted it with solvents in a Tech Inc. PES hollow fibre membrane contactor, and worked out where the resistance to mass transfer lies.

Why this matters

Acetic acid and water boil close together, so distilling dilute streams wastes energy. Solvent extraction works, but mixing and settling the two liquids creates emulsions and large equipment. A membrane contactor keeps the liquids apart on either side of a porous fibre wall and gives a large, fixed contact area in a small module.

What the team did

The team extracted dilute aqueous acetic acid with petroleum ether and with diisopropyl ether, running the solvent first on the shell side and then on the tube side of the module. They measured distribution coefficients and overall mass transfer coefficients at a range of flow rates, and used a resistance-in-series model to split the overall resistance into its three film parts.

Where Tech Inc. came in

The study ran on a Tech Inc. PES hollow fibre membrane contactor. Hollow fibre modules give a very high contact area per unit volume and let researchers switch which fluid runs through the fibres, which is exactly the comparison this work set out to make. See our hollow fibre membranes and the guide to hollow fibre modules.

Results that stand out

  • Raising the solvent flow on either side increased the acetic acid taken into the solvent.

  • The distribution coefficient rose with the shell-side Reynolds number.

  • Diisopropyl ether gave better distribution coefficients than petroleum ether.

  • The highest overall mass transfer coefficient, 11.41 × 10⁻⁶ m/s, came with petroleum ether flowing on the tube side.

  • Reynolds numbers placed the mass transfer in the laminar regime.

What it means for your lab

Membrane contactors are used for liquid extraction, gas absorption and degassing. We build hollow fibre modules in PES, PVDF, PP and PTFE to suit the solvent, and the same SRM group has also used a Tech Inc. contactor for phenol recovery.

The paper

Karunanithi, S. and Prabhakar, S. (2022). Performance of PES membrane contactor on the separation of dilute acetic acid from aqueous forms. International Journal of Membrane Science and Technology 9. doi:10.15379/2410-1869.2022.03

Read the full paper at the publisher for methods, data and figures.

Part of the Research with Tech Inc. series

This post is one of a series on published research made with Tech Inc. equipment and materials. See the full list on Research using Tech Inc. equipment. Next in the series: BITS Pilani Benchmarks a Biodegradable Dye Membrane against Tech Inc. NF Membranes.

Published with our equipment? Send the reference to mail@techincresearch.com and we will feature your work. To discuss equipment for a similar study, call +1 (289) 622-1032 or write to mail@techincresearch.com.

Comments


bottom of page