BITS Pilani Benchmarks a Biodegradable Dye Membrane against Tech Inc. NF Membranes

At a glance. Textile wastewater carries dyes and salt together, and most treatment throws both away. Researchers at BITS Pilani built a thin film nanocomposite membrane that rejects more than 94 per cent of Congo red dye while letting salt through for recovery, and that biodegrades once it is spent. To prove its worth, they tested it head to head against commercial nanofiltration membranes from Tech Inc.
Why this matters
Dye houses and textile mills discharge large volumes of coloured, salty water. Recovering the salt for reuse and removing the dye cuts both cost and pollution. Membranes that do this and then degrade at end of life address a second problem: membrane waste.
What the team did
Animikh Goswami, Banasri Roy and Somak Chatterjee impregnated graphene oxide with iron oxide and built it into a thin selective layer on a PVDF support by interfacial polymerisation. They tuned the graphene oxide loading, characterised the membranes, and tested them with synthetic dye solution, real wastewater, salt solutions and long-term filtration, followed by a biodegradation study.
Where Tech Inc. came in
A new membrane means little without a fair comparison. The team used Tech Inc. commercial nanofiltration membranes (250 Da molecular weight cut-off) as the industrial benchmark under the same test conditions. A well-characterised commercial reference is what gives a research result its credibility with reviewers and with industry.
Results that stand out
With 0.02 wt% graphene oxide, the membrane rejected more than 94% of Congo red at a permeability of 3.6 L/m²·h·bar.
On real wastewater it rejected 72% of the dye over 12 hours.
It outperformed the commercial nanofiltration membranes on dissolved solids, conductivity, salinity, nitrate, sulfate and dye removal.
Sodium chloride and magnesium sulfate recovery reached 70%.
Spent membranes lost 62% of their weight over two months, confirming biodegradability.
What it means for your lab
Benchmark membranes, test cells and cross-flow rigs are the basic kit for nanofiltration research. We supply flat sheet NF, UF, RO and FO membranes as references, along with the test cells and systems to run them. The same BITS Pilani campus also used Tech Inc. polysulfone for gas separation membranes.
The paper
Goswami, A., Roy, B. and Chatterjee, S. (2025). Graphene oxide-iron oxide based thin film nanocomposite membrane for congo red dye removal and simultaneous salt recovery from aqueous stream. Scientific Reports. doi:10.1038/s41598-025-25455-w
Read the full paper at the publisher for methods, data and figures.
Part of the Research with Tech Inc. series
This post is one of a series on published research made with Tech Inc. equipment and materials. See the full list on Research using Tech Inc. equipment. Next in the series: Concentrating Cactus Pear Pigment by Forward Osmosis on Tech Inc. Membranes.
Published with our equipment? Send the reference to mail@techincresearch.com and we will feature your work. To discuss equipment for a similar study, call +1 (289) 622-1032 or write to mail@techincresearch.com.





Comments