Hydrotreating: How It Works and How Catalysts Are Tested in the Lab

Updated: 7 days ago
Full guide: Hydrotreating pilot plants: how a hydroprocessing test unit works, with tables, a specification checklist and FAQs.
At a glance. Hydrotreating reacts a refinery or chemical feed with hydrogen over a catalyst to remove sulphur, nitrogen, oxygen and metals and to saturate olefins and aromatics. It is how refineries make ultra-low-sulphur fuels. Catalyst and process development happen first at lab and pilot scale on units such as the Tech Inc. hydrotreating system and fixed-bed catalyst test unit.
The reactions
Hydrodesulphurisation (HDS): sulphur compounds become hydrocarbons and hydrogen sulphide.
Hydrodenitrogenation (HDN): nitrogen compounds become hydrocarbons and ammonia.
Hydrogenation: olefins and aromatics are saturated.
Hydrodemetallisation: metals such as nickel and vanadium deposit on the catalyst.
Catalysts
Cobalt-molybdenum (CoMo) on alumina for HDS.
Nickel-molybdenum (NiMo) on alumina for HDN and hydrogenation.
Catalysts are activated by sulphiding before use.
Typical conditions
Temperatures of roughly 300 to 400 °C.
Hydrogen partial pressures from about 20 bar for light naphtha to over 100 bar for heavy feeds.
Liquid hourly space velocity and hydrogen-to-oil ratio are set by feed and target sulphur.
Diesel sulphur limits of 10 ppm in Europe and 15 ppm in the United States drive deep desulphurisation.
The process
Feed and hydrogen are mixed and heated.
They flow down through fixed catalyst beds in a trickle-bed reactor.
The effluent is cooled and separated in a high-pressure separator.
Hydrogen sulphide is removed and hydrogen is recycled.
The product is stripped of light ends.
Testing catalysts in the lab
Micro-reactors with a few grams of catalyst screen formulations quickly.
Bench and pilot units with larger beds confirm activity and stability over weeks.
Good practice includes isothermal reactors, catalyst dilution with inert fines for even flow, mass flow control of hydrogen, a high-pressure feed pump, a back-pressure regulator, gas-liquid separation and sampling or online analysis.
Safety systems need hydrogen and H2S detection, pressure relief and interlocks.
Related Tech Inc. equipment
Frequently asked questions
What is the difference between hydrotreating and hydrocracking? Hydrotreating removes contaminants with little change in boiling range; hydrocracking breaks heavy molecules into lighter products at higher severity.
Can a lab unit run real refinery feeds? Yes. Units built for the pressure, temperature and H2S involved can run straight-run and cracked feeds.
Send your requirements to mail@techincresearch.com or call +1 (289) 622-1032.





Comments