Hydraulic Test Benches and Nitrogen Charging Carts for Aircraft, Naval and Plant Maintenance

At a glance. Maintenance workshops for aircraft, ships, mining machines and process plants overhaul hydraulic pumps, motors, actuators and valves, and recharge struts, accumulators and tyres with nitrogen. Two pieces of equipment carry most of that work: a hydraulic component test bench that proves each part, and a mobile nitrogen charging cart that sets each charge pressure.
Testing hydraulic components
Mount. The component is fitted to its fixture and connected to the test manifold.
Supply. A variable-speed power unit delivers oil at the flow and pressure the procedure calls for, with heating, cooling and fine filtration to keep the oil clean.
Measure. Calibrated meters record flow, pressure, temperature and internal leakage at each step; pump benches also measure torque and efficiency.
Report. The software compares the readings with the limits from the overhaul manual and prints a pass or fail report.
Benches are built for pumps and motors, for actuators and valves, for servo valves, or for hoses and fittings. Some need a second fluid circuit so that components for different fluids are never mixed, and an intensifier for proof tests well above working pressure.
Charging with nitrogen
Landing-gear struts, hydraulic accumulators, aircraft tyres and gas springs all lose nitrogen in service. A charging cart carries nitrogen cylinders, an air-driven or electric booster, fine-adjustment regulators, test gauges, relief valves and charging hoses with the right adapters:
Booster. Reaches the full charge pressure, often about 350 bar, even when the cylinders are partly empty.
Regulation. Coarse and fine regulators set the charge in small steps.
Safety. Relief on every stage and a vent valve that empties the hose before it is disconnected.
Mobility. Pneumatic tyres, a brake and a tow bar for the flight line or the yard.
Where Tech Inc. equipment fits
Tech Inc. builds the hydraulic component test bench and the high-pressure nitrogen charging cart, as well as gas booster units, automated hydraulic pressure control systems and safety valve test benches.
Related reading
Sources
Aviation Maintenance Technician Handbook – Airframe, Volume 2 (landing gear, wheels and tyres) – US Federal Aviation Administration
This guide is general information. Test procedures and charge pressures come from the component maker's or the operator's manuals.





Comments