top of page

Impulse and Cyclic Pressure Testing of Hoses and Components

Writer: Tech Inc
Tech Inc
4 hours ago
1 min read

At a glance. An impulse tester applies a repeated pressure waveform, often with a fast rise and a peak above working pressure, to parts held in a heated, guarded chamber, and counts the cycles to failure. The Tech Inc. Cyclic Pressure and Impulse Test System uses a servo-hydraulic intensifier and tests several parts at once.

Test types

Test

Waveform

Typical parts

Impulse

fast rise, peak, hold

hoses and fittings

Cyclic

slower sine or trapezoid

filters, vessels, valves

Burst after cycling

ramp to failure

design verification

Standards often used

  • ISO 6803 for hydraulic hose impulse tests.

  • ISO 10771-1 for fatigue of hydraulic components.

  • SAE J343 for hose test methods.

What to specify

  1. Peak pressure and waveform.

  2. Frequency and target cycles.

  3. Oil temperature.

  4. Number of test stations and part sizes.

Frequently asked questions

Why heat the oil? Many standards test at elevated temperature because heat speeds rubber and seal ageing.

How long does a test run? Hundreds of thousands of cycles may take several days at 1 Hz.

Comments


bottom of page