Lab and Pilot Carbon Capture Rigs: What to Specify

At a glance. Most post-combustion carbon capture uses a liquid solvent, usually an amine, that absorbs CO2 in one column and releases it in another when heated. Lab and pilot rigs reproduce that cycle on a small scale so researchers can compare solvents, test packings and measure the energy needed per tonne of CO2.
How the rig works
Gas preparation. Flue gas, or a synthetic blend of CO2, nitrogen and air from mass-flow controllers, is cooled and fed to the absorber.
Absorption. The gas rises through packing against falling lean solvent, which absorbs the CO2. A wash section limits solvent loss.
Heat exchange. Rich solvent is heated by hot lean solvent in the lean–rich exchanger.
Stripping. In the stripper, the reboiler heats the solvent and releases CO2, which leaves through the overhead condenser.
Return. Cooled lean solvent returns to the absorber.
What to specify
Capacity, typically 1 to 5 kg CO2 per day for lab rigs and 10 to 100 kg per day for pilots.
Gas source: blended synthetic gas, or a slipstream of real flue gas with conditioning.
Columns: glass for visibility at lab scale, stainless steel for pilots; packing type and height.
Solvents to be tested, which set the materials and the reboiler temperature.
Measurements: CO2 in and out, solvent loading sampling points, reboiler duty and full data logging.
Siting: laboratory frame or container for trials at an industrial site.
Keeping the solvent clean
Amine picks up dirt, corrosion products and degradation products, which cause foaming and loss of capacity. A slipstream filtration package with a particle prefilter, an activated-carbon bed and an after-filter keeps it clean, at pilot scale as well as in full plants.
Where Tech Inc. equipment fits
Tech Inc. builds the lab and pilot carbon capture rig, the amine and solvent filtration package and pleated amine filter cartridges, as well as the CO2 dehydration unit, the CO2 quality analyser system and the pressurised gas-fermentation pilot reactor for CO2 use.
Related reading
Sources
IPCC Special Report on Carbon Dioxide Capture and Storage – Intergovernmental Panel on Climate Change, 2005
This guide is general information. Each rig is designed to the research plan and the site's safety requirements.





Comments