Process Note: Filtration in Amine Gas Sweetening Units

At a glance. Amine units remove H2S and CO2 from natural gas, refinery gas and syngas. The solvent, an aqueous amine such as MDEA or DEA, circulates between an absorber and a regenerator. Over time it collects iron sulfide, corrosion products, heavy hydrocarbons, degradation products and treating chemicals. These cause foaming, lost capacity, fouled exchangers and corrosion. Good filtration is the cheapest way to keep an amine unit stable, and operators across the world treat it as part of the process, not an accessory.
Where the filters go
Inlet gas separation. A filter separator or coalescer ahead of the absorber stops liquid hydrocarbons, compressor oil and solids entering the solvent. This prevents more problems than any solvent filter.
Rich amine particle filter. Placed after the flash drum, it removes iron sulfide and other solids before they reach the lean–rich exchanger.
Lean amine particle filter. Often a side stream of the lean solvent, it catches solids formed in the regenerator.
Activated carbon filter. On a side stream, carbon adsorbs dissolved hydrocarbons and surface-active contaminants that cause foaming.
Post-carbon filter. A particle filter after the carbon bed stops carbon fines entering the system.
Treated gas coalescer. Downstream of the absorber, a coalescer recovers amine mist carried over with the sweet gas.
Design points
Side-stream rate. A fraction of the circulation through the filters is typical; more where solids loading is high.
Element rating. Pleated amine filter cartridges with a fine absolute rating capture iron sulfide that coarse bags pass.
Differential pressure monitoring so elements are changed on condition, not left in bypass.
Carbon bed sizing for enough contact time and a planned change-out interval.
Safe change-out, as spent elements can carry pyrophoric iron sulfide and H2S.
Signs the filtration is not working
Foaming episodes and rising absorber differential pressure.
Dark, cloudy or black solvent.
Fouled lean–rich exchangers and reboiler tubes.
Short element life followed by bypassed housings.
Where Tech Inc. equipment fits
Tech Inc. supplies pleated amine filter cartridges, gas coalescer filter elements, filter separator and coalescer skids, liquid sampling systems for solvent samples and chemical injection skids for antifoam dosing. Replacement elements can be matched to existing housings using our filter element cross-reference.
Related reading
This note is general guidance. Each system is designed to the project's process data and the applicable codes and standards.





Comments