top of page

VIT Upgrades Biogas on Coated PES Hollow Fibres: 20,522 Barrer CO2 Permeability

Writer: Tech Inc
Tech Inc
14 hours ago
2 min read

At a glance. India's compressed biogas programme needs methane purer than 95 per cent. At Vellore Institute of Technology, S. Nithin Mithra and Sandeep Ahankari coated PES hollow fibres with a cellulose nanocrystal layer carrying L-arginine, and reached a CO₂ permeability of 20,522 Barrer with a selectivity of 33 at only 1 bar.

Why this matters

Raw biogas is about 60 per cent methane and 40 per cent CO₂. To count as clean fuel, methane must rise above 95 per cent. Most upgrading plants use water scrubbing or high-pressure membranes, both energy-hungry. A membrane that works at near-atmospheric pressure would suit small digesters and low-pressure storage. See our comparison of biogas upgrading technologies.

What the team did

The team coated a polyethersulfone hollow fibre substrate with a selective layer of polyvinyl alcohol containing cellulose nanocrystals (0 to 2 wt%) and L-arginine as a CO₂ carrier. In this facilitated transport layer, the amino acid reacts reversibly with CO₂ and shuttles it across, while methane cannot use that route. The fibres were stacked in a chamber and tested with biogas at 90% relative humidity and 0.8 to 1 bar.

Where Tech Inc. came in

The PES hollow fibres that carry the selective layer came from Tech Inc. In a composite membrane the substrate sets the mechanical strength and the resistance under the coating, so a uniform, defect-free fibre is the starting point. Our hollow fibre membranes are supplied in research quantities for coating and module work, and hollow fibre spinning machines let groups make their own.

Results that stand out

  • The CNC1/PVA-LA layer (1.0 wt% cellulose nanocrystals) had the lowest water contact angle, 17°, and so the best moisture uptake for CO₂ transport.

  • At 1.5 wt% CNC, crystallinity rose to 66% but the contact angle increased to 20°, reducing facilitated transport.

  • Permeability and selectivity rose with CNC up to 1 wt%, then fell.

  • At 90% RH and 1 bar, CNC1/PVA-LA reached a CO₂ permeability of 20,522 Barrer and a CO₂/CH₄ selectivity of 33.

What it means for your lab

Composite hollow fibre work needs substrates, coating equipment and a way to test gas permeation. We supply all three; see coating hollow fibres for gas separation. Professor Ahankari's group also used a Tech Inc. casting machine for supercapacitor films.

The paper

Mithra, S. N. and Ahankari, S. S. (2024). Biogas purification using cellulose nanocrystals/polyvinyl alcohol coated facilitated transport hollow fiber membranes with L-arginine as CO2 carrier. Journal of Applied Polymer Science. doi:10.1002/app.56332

Read the full paper at the publisher for methods, data and figures.

Part of the Research with Tech Inc. series

This post is one of a series on published research made with Tech Inc. equipment and materials. See the full list on Research using Tech Inc. equipment. Next in the series: Jain University's Fouling-Resistant CA Blend, Benchmarked against Tech Inc. Membranes.

Published with our equipment? Send the reference to mail@techincresearch.com and we will feature your work. To discuss equipment for a similar study, call +1 (289) 622-1032 or write to mail@techincresearch.com.

Comments


bottom of page