top of page

Refinery Chemical Injection and Precision Dosing: How to Specify

Writer: Tech Inc
Tech Inc
5 days ago
2 min read

At a glance. Refineries dose antifoulants, neutralisers, filming amines, corrosion inhibitors and wash water into their units around the clock. Pilot plants and catalyst rigs dose feeds and additives at very small rates. Both need the right pump, a way to prove the dose, and materials that survive the chemical at the injection point.

Refinery process chemicals

Typical injection points include crude and vacuum unit overheads (neutralisers, filming amines, wash water), preheat trains (antifoulants), desalters (demulsifiers), hydrotreater and FCC sections and cooling water. Most chemicals are bought as a service, with the chemical company supplying the injection skid.

What to specify

  1. Pumps. Diaphragm or plunger metering pumps to API 675, sized for the flow range and the injection pressure, with duty and standby where the dose is critical.

  2. Calibration pot. A graduated column on the suction to check the actual pump rate.

  3. Pulsation dampers and back-pressure valves for steady, accurate delivery.

  4. Materials. 316L for most chemicals; duplex or C-276 for aggressive ones.

  5. Control. Manual stroke, variable speed or automatic flow control from a meter.

  6. Injection points. Quills that place the chemical in the flowing stream, and a static mixer where fast mixing is needed.

Lab and pilot precision dosing

At pilot scale, the feed rate drives the mass balance, so it must be small, steady and measured.

  • HPLC-type dual-piston pumps give steady flows from microlitres to tens of millilitres per minute at high pressure.

  • Coriolis-controlled pumps hold a mass-flow set point even as the fluid's properties change.

  • A feed vessel on a balance records exactly what was fed.

  • Standard signals let the module talk to the rig PLC.

Common problems

  • Pumps sized near the bottom of their range, where accuracy is poor.

  • Gas in the suction line, which stops metering pumps delivering.

  • Corrosion at the injection point because the chemical meets the wall undiluted.

Where Tech Inc. equipment fits

Related reading

Sources

This guide is general information. Dosing rates and injection designs come from the chemical programme and the operator's standards.

Comments


bottom of page