top of page

Process Note: How Crude Oil Desalting Protects a Refinery

Writer: Tech Inc
Tech Inc
10 hours ago
2 min read

At a glance. Crude oil carries brine droplets and solids from the reservoir. When it is heated in a refinery, chloride salts hydrolyse to hydrochloric acid that attacks the overhead of the crude column, and salts and solids foul preheat exchangers and furnace tubes. A desalter washes the crude with fresh water and uses an electric field to separate the water again, taking the salt with it. Refineries and some production facilities across the world run one or two desalting stages before the crude unit.

How the process works

  1. Preheat. Crude is heated to lower its viscosity so water droplets can settle.

  2. Wash water. Fresh or recycled wash water is injected, typically a few per cent of the crude flow, to dilute the brine.

  3. Mixing. A mix valve or static mixer creates fine droplets so wash water contacts the brine. Too little mixing leaves salt behind; too much creates an emulsion that will not separate.

  4. Demulsifier. A demulsifier chemical, dosed by a chemical injection skid, weakens the oil–water interface.

  5. Electrostatic coalescence. In the desalter vessel, electrodes apply a high-voltage field that makes droplets collide and grow until they settle.

  6. Separation. Desalted crude leaves from the top; brine leaves from the bottom to the effluent system.

  7. Mud washing. Solids that settle at the bottom are flushed out periodically.

Design points

  • Temperature, set by crude viscosity and density difference, within the limits of the electrical internals.

  • Wash water quality and rate, including pH control.

  • Mix valve pressure drop, adjusted for each crude.

  • Interface level control, which keeps the oil–water interface away from the electrodes.

  • Two-stage operation where crude salt content is high or the outlet target is strict.

  • Effluent brine oil content, which affects the wastewater plant downstream.

Common problems

  • Stable emulsions from heavy or opportunity crudes, solids and some production chemicals.

  • Electrical short-circuiting when the interface rises or an emulsion layer grows.

  • Oil under-carry into the brine, which loads the wastewater plant.

  • Rag layer build-up at the interface.

Where Tech Inc. equipment fits

Tech Inc. builds desalter skids, chemical injection skids for demulsifier and caustic dosing, produced water treatment packages for the brine, oil content analysers and liquid sampling systems for crude and brine samples. Each package is engineered to the client's crude assay and targets, built in-house and factory-tested.

Related reading

This note is general guidance. Each unit is designed to the project's process data and the applicable codes and standards.

Comments


bottom of page