Skids for Mines and Metal Plants: Reagent Dosing, Diesel Polishing, TiCl4 Transfer and Battery Acid

At a glance. Concentrators dose reagents to every flotation cell, mine fleets burn diesel that is often dirty and wet, titanium plants move titanium tetrachloride that fumes in moist air, and battery plants dilute sulphuric acid with a great deal of heat. Each job is a skid with the right materials, closed handling and measured flow.
Reagent dosing at concentrators
Collectors, frothers, depressants and flocculants are made up to strength in agitated tanks, held in day tanks and dosed by metering or peristaltic pumps to each addition point. Flow is measured and trimmed from the plant control system, calibration columns check the pumps, and bunds and interlocks protect operators from hazardous reagents. Recovery depends on steady dosing, and less reagent is wasted when the dose follows the plant's set point.
Diesel filtration at mine sites
High-pressure injection engines fail early on dirty or wet fuel. A polishing skid draws fuel through a strainer, a water coalescer with automatic drain and fine particle filters, then returns it to the tank or sends it on to dispensing. Filtering on receipt, in storage and on issue protects the engines; differential-pressure gauges, and optionally an online sensor, show the fuel condition against the engine maker's ISO 4406 code.
Titanium tetrachloride transfer
TiCl4 reacts with moisture in the air to give hydrochloric acid and titanium oxide fumes. Sponge and chloride-route pigment plants therefore move it only in closed, dried systems:
Lines are dried and purged with nitrogen before liquid is admitted.
TiCl4 is pressure-transferred or pumped through filters, and, where required, purified by distillation.
After transfer, the lines are blown down with nitrogen and the vent gas is scrubbed.
Battery acid dilution
Lead-acid plants dilute concentrated sulphuric acid to the gravity each step needs. Acid is metered into a water stream, never water into acid, mixed in a lined mixer and cooled to remove the heat of dilution. An in-line densitometer trims the water flow so every batch stays on gravity.
Where Tech Inc. equipment fits
Tech Inc. builds the flotation and leaching reagent dosing skid, the diesel fuel filtration and polishing skid, the titanium tetrachloride transfer and purification skid and the battery acid dilution and cooling skid, as well as leach filtration trains and mixer-settler solvent extraction trains.
Related reading
Sources
Worldwide Fuel Charter 2019 – Gasoline and diesel fuel – ACEA, Alliance for Automotive Innovation, EMA and JAMA
Titanium tetrachloride chemical datasheet – NOAA CAMEO Chemicals
Sulfuric acid chemical datasheet – NOAA CAMEO Chemicals
This guide is general information. Each skid is designed to the plant's chemicals, flows, materials rules and area classification.





Comments