top of page

Process Note: Aviation Fuel Filtration from Fuel Farm to Wing

Writer: Tech Inc
Tech Inc
10 hours ago
2 min read

At a glance. Water and particles in jet fuel can block aircraft fuel filters, encourage microbial growth and, in extreme cases, cause ice in fuel systems. Airports, military bases and helidecks across the world therefore filter fuel at every transfer, from receipt into the fuel farm to delivery into the aircraft, and check it with daily sampling and differential pressure records. The industry's standards, notably the Energy Institute specifications for aviation filtration and the operating procedures used by fuel suppliers and airlines, set the type of equipment and the checks.

How fuel moves and where it is filtered

  1. Receipt. Fuel arriving by pipeline, ship or road tanker passes through receipt filtration, usually microfilters and filter water separators, before it enters storage.

  2. Storage. Tanks are designed with floating suctions, sloped bottoms and sumps so water and sediment settle and can be drained.

  3. Issue from the fuel farm. Fuel leaving storage passes through a fuel farm filtration skid, commonly filter water separators.

  4. Hydrant or refueller. Hydrant dispensers and refuellers carry their own filtration, a filter water separator or equivalent, as the last barrier before the aircraft.

  5. Offshore and remote sites. Helidecks and remote strips use compact packages such as a helideck refuelling skid with filtration, metering and sampling built in.

How a filter water separator works

A filter water separator has two stages. Coalescer elements remove particles and merge fine water droplets into large drops that fall to the sump. Separator elements, with a hydrophobic screen, repel the remaining drops so only dry fuel passes. Water is drained from the sump, and differential pressure across the vessel shows when elements need changing.

Checks that keep fuel clean

  • Daily sumps and visual checks on tanks, vessels and vehicles.

  • Differential pressure recording, corrected for flow, to spot loading or element failure.

  • Membrane and water detection tests on samples taken from closed-loop samplers.

  • Element change-out on condition, at maximum differential pressure or at the maximum service life.

Common problems

  • Surfactants from contaminated fuel, which disarm coalescers and let water through.

  • Microbial growth at fuel–water interfaces in tanks that are not drained regularly.

  • Wrong elements fitted in housings, or elements not qualified to the vessel.

  • Missed records, which make an incident impossible to trace.

Where Tech Inc. equipment fits

Tech Inc. supplies filter water separators for aviation refuellers, aviation fuel farm filtration skids, helideck refuelling skids and strainer–air eliminators for metering lines, built and factory-tested for airports and operators across the world.

Related reading

This note is general guidance. Aviation fuelling equipment must meet the specifications and procedures that apply at each airport and to each operator.

Comments


bottom of page