Process Note: Membrane Distillation for Brine Concentration and Zero Liquid Discharge

At a glance. Conventional reverse osmosis is limited by pressure: as brine becomes more concentrated its osmotic pressure rises, and standard elements stop at brines of around 70,000 mg/L of dissolved salts. Membrane distillation (MD) uses heat instead. Water evaporates through the pores of a hydrophobic membrane and condenses on the other side, while dissolved salts stay behind. Because the driving force is a difference in vapour pressure, MD keeps working at concentrations close to saturation and can run on low-grade heat. Researchers and plants across the world are testing MD between RO and a crystalliser in zero liquid discharge (ZLD) schemes.
Where MD sits in a ZLD scheme
Pretreatment and softening to reduce scale-forming ions.
Reverse osmosis removes most of the water at the lowest energy cost.
Membrane distillation concentrates the RO brine further, using waste heat or solar heat where available.
A crystalliser or evaporation pond recovers solid salts and the last of the water.
Distillate polishing if the product water needs it.
MD configurations
Direct contact MD (DCMD): hot feed and cold distillate flow on either side of the membrane. It is simple but loses more heat by conduction.
Air gap MD (AGMD) and permeate gap MD (PGMD): a gap between the membrane and a condensing surface cuts heat loss and allows heat recovery.
Vacuum MD (VMD): a vacuum on the permeate side raises the flux.
Sweeping gas MD (SGMD): a gas stream carries the vapour to an external condenser.
Design points
Membrane: hydrophobic PTFE, PVDF or polypropylene, chosen for pore size, porosity, thickness and liquid entry pressure.
Feed temperature, commonly about 50 to 90 °C, and the heat source that supplies it.
Heat recovery, measured as gained output ratio (GOR) or specific thermal energy use.
Temperature and concentration polarisation at the membrane surface.
Scaling and wetting resistance, particularly where surfactants, oils or organics are present.
Module format: flat sheet, hollow fibre or spiral wound.
Common problems
Pore wetting, where feed liquid enters the pores and salt reaches the distillate. Rising distillate conductivity is the warning sign.
Scaling by calcium sulphate, calcium carbonate and silica as the brine concentrates.
Low thermal efficiency when heat recovery is poor.
Flux decline from organic fouling or scale.
Results that do not scale up because laboratory tests used different temperatures, flows or membranes from the pilot.
Where Tech Inc. equipment fits
Tech Inc. builds MD equipment from bench to pilot scale: the lab scale membrane distillation test skid, the pilot membrane distillation system with DAQ, the full membrane distillation system with DAQ, membrane distillation test cells and the crystallisation and membrane concentration package. Our testing services can generate data on a client's own brine.
Related reading
This note is general guidance. Process design for brine concentration depends on the brine chemistry, the heat available and pilot results.





Comments