top of page

Application Note: Acid Preparation, Cooling and Circulation in Lead-Acid Battery Plants

Writer: Tech Inc
Tech Inc
5 days ago
2 min read

At a glance. Lead-acid batteries for cars, inverters, telecom and motive power use sulphuric acid at several gravities: for pasting, for filling, for formation and as the finished electrolyte. The plant has to prepare that acid accurately, take away a great deal of heat and keep acid mist out of the workplace.

Preparing acid to gravity

  1. Concentrated sulphuric acid and demineralised water are metered in the right ratio.

  2. Acid is always added to water, never the reverse, and mixed in a lined mixer.

  3. The heat of dilution is removed in a cooler made of PTFE, graphite, PVDF or a suitable alloy.

  4. An in-line densitometer trims the water flow so the acid leaves at the set specific gravity, and storage tanks hold each grade.

Formation and cooling

Formation, the first charge that turns the pasted plates into active material, produces heat and gas. Plants form batteries in tanks or in their containers, and many circulate cooled acid through the batteries during formation so the temperature stays within limits and the electrolyte gravity is adjusted at the end. Circulation systems need acid-resistant pumps, coolers, filters and controls.

Fume and mist

Formation and acid handling release acid mist. Extraction hoods and wet scrubbers capture it before the air is released.

Lead recycling

Recyclers drain and neutralise spent battery acid and handle sulphur dioxide from smelting, which brings its own acid-handling and scrubbing equipment.

Where Tech Inc. equipment fits

Related reading

Sources

This note is general information. Acid gravities, cooling duties and materials are set for each plant.

Comments


bottom of page