ISO 3448 Explained: ISO Viscosity Grades for Industrial Lubricants, from VG 2 to VG 3200

ISO 3448:1992, Industrial liquid lubricants — ISO viscosity classification (edition 2, confirmed 2023) is the grading scheme behind the ISO VG numbers. ISO's abstract says it establishes a viscosity classification for industrial liquid lubricants and related fluids, including mineral-oil lubricants, hydraulic fluids and electrical oils, normally using the kinematic viscosity method of ISO 3104 (the equivalent of ASTM D445); pure chemicals and natural products used as lubricants may fall outside it.
What it covers
Twenty grades from ISO VG 2 to ISO VG 3200, each named by its mid-point kinematic viscosity at 40 °C in mm²/s (cSt), with limits of ±10 % around the mid-point: ISO VG 46 is 41.4 to 50.6 mm²/s at 40 °C. Each grade is roughly 50 % more viscous than the one below. The classification says nothing about quality, additives or performance; it is a viscosity label only.
Our commentary
40 °C is the reference, not the operating temperature. Two VG 46 oils with different viscosity indices (ASTM D2270) can differ noticeably at 80 °C; where the bearing runs hot, compare at the operating temperature.
Cross-references are approximate. SAE 20 engine oil, AGMA 2 gear oil and ISO VG 68 overlap but are defined differently (SAE at 100 °C and cold cranking, AGMA at 40 °C with its own bands); never substitute by number alone.
Grade confusion is a lube-room problem. Most wrong-oil incidents are a VG 32 topped up with VG 68 from an unlabelled container. Colour-coded containers, tagged dispensing points and a lubricant identification scheme prevent them.
Blending to grade needs a measured viscosity on the finished batch, because viscosity does not blend linearly; blending charts and our lube oil viscosity calculator give the starting ratio.
Our equipment
Lube room dispensing systems and lube racks, colour-coded oil transfer containers, lubricant identification systems, bulk oil storage and dispensing work centres and lube oil blending skids. All our standards guides.
Send your application, materials and the standards your contract names to mail@techincresearch.com or call +1 (289) 622-1032, and we will return a configuration, datasheet and quotation.
This article is our commentary on the standard's published scope, not a substitute for the standard itself; always work to the current edition named in your contract. Equipment specifications may change; performance depends on the application, how the equipment is used and operation in line with the operation manual.
Sources
ISO, ISO 3448:1992 Industrial liquid lubricants — ISO viscosity classification, standard page and abstract.





Comments