ISO 2719 Explained: Flash Point by Pensky-Martens Closed Cup, Procedures A, B and C

ISO 2719:2025, Determination of flash point — Pensky-Martens closed cup method (edition 5, November 2025) is the international equivalent of ASTM D93. ISO's abstract describes three procedures using the Pensky-Martens closed cup tester to find the flash point of flammable liquids, liquids with suspended solids, liquids that form a surface film and biodiesel, in the range 40 °C to 370 °C: procedure A for distillate fuels, lubricating oils and paints, procedure B for residual fuels and mixtures containing solids, and procedure C for fatty acid methyl esters; water-borne paints are excluded.
What it covers
The sample is heated in a closed cup with a stirrer at a set rate and an ignition source is applied at intervals; the flash point is the lowest corrected temperature at which the vapour ignites. The closed cup keeps the vapour that an open cup would lose, so closed-cup values are lower and are the ones used for classification.
Our commentary
Classification thresholds. Transport and storage rules draw their lines at closed-cup flash points (23 °C and 60 °C are the common ones), so a product a few degrees either side of a line changes category, with consequences for tank design, earthing and electrical zoning.
Heated storage must stay below the flash point by a margin; the fuel oil heater set point is chosen from this test, not from the pour point alone.
Contamination shows up first here. A diesel or lube oil with a flash point well below specification has picked up gasoline, solvent or light process fluid; a sample that loses light ends in an open bottle reads high and hides the problem, which is why closed sampling matters.
The 2025 edition brought the procedure for FAME into the main text and refined the ranges; cite the edition in a specification.
Our equipment
Diesel fuel polishing skids, fuel farm filtration skids, fuel oil heating and pumping skids, truck and tanker loading skids and portable closed samplers. Related guide: ASTM D97, D5950 and D93. All our standards guides.
Send your application, materials and the standards your contract names to mail@techincresearch.com or call +1 (289) 622-1032, and we will return a configuration, datasheet and quotation.
This article is our commentary on the standard's published scope, not a substitute for the standard itself; always work to the current edition named in your contract. Equipment specifications may change; performance depends on the application, how the equipment is used and operation in line with the operation manual.
Sources
ISO, ISO 2719:2025 Determination of flash point — Pensky-Martens closed cup method, standard page and abstract.





Comments