Choosing a Laboratory High-Pressure Reactor: Volume, Rating, Material and Spares

At a glance. Choose the volume from your batch at about two-thirds fill, the pressure and temperature rating from the worst case with a margin, and the material from the chemistry. Then pick the stirring, heating and controller. For many small screening runs, a micro multi-reactor is quicker than one large vessel; for simple low-pressure hydrogenations, a shaker is enough.
Volume
100 to 600 mL suits most catalyst, polymer and hydrogenation work on the bench.
1 to 2 L gives more product for analysis and scale-up checks.
5 to 20 L is for kilo-lab and small production runs, with a floor stand and a hoist for the head.
Leave headspace for gas, foaming and expansion; about two-thirds full is a common working maximum.
Rating
The vessel rating must cover the highest pressure and temperature the run can reach, including exotherms and gas generated. Smaller vessels are usually rated higher; larger ones lower. Every vessel needs relief: a rupture disc rated to the vessel, often with a relief valve, as described in ISO 4126-2 for bursting-disc devices.
Material
316 stainless steel for most organic chemistry and hydrogenation.
Alloy C-276 for chlorides and many acids.
Alloy 625 or titanium where chlorides, oxidants or high temperature combine.
PTFE or glass liners protect the vessel in small runs and make cleaning easier, but limit temperature.
Stirring, heating and control
A magnetic drive keeps the stirrer sealed. Impeller choice matters: gas-entrainment impellers for hydrogenation, anchors for viscous polymers. Heating is by band, block or jacket. One controller across sizes, with logging of temperature, pressure and stirrer speed, keeps data comparable.
When another tool fits better
Micro multi-reactor (6 to 24 vessels of 10 to 100 mL) for screening catalysts and conditions in parallel.
Shaker hydrogenator (to about 4 bar) for simple low-pressure hydrogenations.
Nitrogen-decompression vessel for gentle cell disruption in biotechnology.
Spares that keep a reactor running
Head gaskets and O-rings, magnetic-drive bearings, impellers, liners, thermocouples and rupture discs are the parts that wear or are used up. Keep a seal kit and spare discs for each size in stock.
Where Tech Inc. equipment fits
Tech Inc. builds a standard high-pressure reactor range, reactor spares and accessories, micro multi-reactor systems, shaker hydrogenators, cell-disruption vessels and high-pressure laboratory hydrogen generators.
Related reading
Sources
NFPA 2, Hydrogen Technologies Code (2023 edition) – National Fire Protection Association, via ANSI
This guide is general information. Each reactor is selected and rated from the client's chemistry and conditions.





Comments