top of page

Process Note: Gas Turbine Inlet Air Filtration in Dusty and Humid Climates

Writer: Tech Inc
Tech Inc
10 hours ago
2 min read

At a glance. A gas turbine compressor draws in vast volumes of air every hour. Dust erodes blades, salt corrodes the hot section, and fine particles and oily aerosols foul the compressor, which cuts output and raises fuel use. Inlet filtration removes these, but every pascal of pressure drop across the filters also costs output. Power plants, pipelines and offshore platforms across the world choose their filter stages to balance protection against pressure drop for their own climate.

The filter stages

  1. Weather hoods and screens stop rain, birds and debris.

  2. Moisture separators or coalescing prefilters remove rain, fog and salt-laden droplets, which matters on coasts and offshore.

  3. Prefilters capture coarse dust and extend the life of the final filters.

  4. Final filters, high-efficiency cartridges or panels, capture the fine particles that cause fouling. Efficiency classes are defined by standards such as ISO 16890 and EN 1822.

  5. Pulse cleaning. In deserts, self-cleaning cartridge systems fire reverse pulses of compressed air to shed dust cake from the cartridges while running.

Design points

  • Site dust and salt loading, including sandstorm frequency and coastal exposure.

  • Humidity and fog, which can make dust cake swell and pressure drop jump.

  • Face velocity through each stage, which drives both efficiency and pressure drop.

  • Allowable pressure drop, traded against output and fuel cost.

  • Change-out strategy, on condition, aligned with planned outages.

  • Sealing, as air that bypasses a filter through a poor gasket carries dirt straight in.

Common problems

  • Sudden pressure drop rises in fog or rain, which can trip the turbine.

  • Leaks at seals and frames, which let dirt bypass excellent filters.

  • Compressor fouling that returns quickly after washing because the final stage is too coarse.

  • Over-frequent pulse cleaning, which wastes compressed air and shortens cartridge life.

Where Tech Inc. equipment fits

Tech Inc. supplies gas turbine inlet filter cartridges, lube and control oil filter elements, fuel gas conditioning skids and lube oil consoles for turbines. Replacement cartridges can be matched to existing housings using our filter element cross-reference.

Related reading

This note is general guidance. Filter selection follows the turbine manufacturer's requirements and the site's conditions.

Comments


bottom of page