Application Note: Setting Up a Gas Cylinder Requalification Line

At a glance. Breathing-apparatus, fire-suppression, medical and industrial gas cylinders must be inspected and retested at intervals set by the regulations and the cylinder standard. A requalification line takes each cylinder through the same sequence, records the result and returns it to service or condemns it.
The sequence
Receipt and identification. The cylinder is logged by serial number, maker, standard and last test date.
Depressurising. Residual gas is vented or recovered safely.
Valve removal. The valve is removed with a torque machine and set aside for service.
External inspection. Dents, cuts, corrosion, fire damage and illegible markings are checked against the rejection criteria.
Internal inspection. An inspection lamp shows corrosion, contamination or cracks inside.
Hydrostatic test. In the water-jacket method the cylinder is pressurised to its test pressure inside a water-filled jacket; total and permanent volumetric expansion are measured, and the ratio decides pass or fail. Some cylinder types use other methods set by their standard.
Drying. Warm, dry air removes all water before the valve is refitted.
Valve service and refitting. Valves are cleaned, serviced or replaced and refitted to the specified torque.
Marking and records. The test date and station mark are applied, and the certificate and records are filed.
Line layout
Arrange the steps in a single flow so cylinders never wait in the wrong place: receipt and venting, valve removal, inspection, testing, drying and valve refitting, marking and dispatch. Keep the hydrostatic test in a protected area with an interlocked jacket lid.
Equipment checklist
Water jacket with hoist and test pump, expansion measurement and calibrated transducer, inspection lamp, drying station, valve torque machine, marking tool, software for records and certificates, and reference cylinders or standards for daily checks.
Where Tech Inc. equipment fits
Tech Inc. builds the cylinder requalification test station and, for cylinder makers, the cylinder hydrostatic and pressure-cycling test bench and automated burst pressure testers.
Related reading
Sources
ISO 11623:2023, Gas cylinders – Composite cylinders and tubes – Periodic inspection and testing – ISO
49 CFR 180.205, General requirements for requalification of specification cylinders – US Code of Federal Regulations, via Cornell LII
This note is general information. Intervals, methods and rejection criteria follow the cylinder standard and the regulations the test station is approved under.





Comments