Spent Solvent Recycling: How a Batch Still Pays for Itself

At a glance. Pharma plants, paint and ink makers, printers and finishing lines use solvents for cleaning and processing, then pay to send the dirty solvent away as hazardous waste. A batch distillation still boils the solvent off its contaminants, condenses it as clean solvent for reuse and leaves a small residue. Both the purchase bill and the disposal bill fall.
How a still works
Charge. Spent solvent is pumped into the still.
Boil. A thermal-oil, steam or electric jacket heats the charge; a scraper agitator keeps the wall clean as the residue thickens.
Condense. The vapour passes to a water-cooled condenser and collects as clean solvent in a receiver.
Discharge. At the end of the batch the residue is cooled and emptied through a bottom valve or into a liner bag.
A vacuum lowers the boiling point for heavy or heat-sensitive solvents. A short fractionation column separates two solvents when their boiling points are far enough apart.
Sizing and payback
Volume. Size the still to the solvent produced per shift or per day, with headroom for growth.
Recovery. Most of the solvent in the feed is typically recovered; a test distillation of your own solvent gives the real figure.
Quality. Check the recovered solvent for water content or density before reuse.
Payback. Compare the value of the solvent recovered plus the disposal cost avoided with the cost of the still, energy and cooling water.
Safety
Solvent stills handle flammable vapours, so motors and instruments are rated for the hazardous area, the system is earthed, and interlocks stop heating on high temperature, high pressure or loss of cooling. Nitrogen purging before start-up keeps air out of the system.
Where Tech Inc. equipment fits
Tech Inc. builds the spent solvent recycling still, and for continuous or heat-sensitive duties the falling-film solvent recovery skid, industrial rotary evaporators and the NMP solvent recovery unit.
Related reading
Sources
ICH Q7, Good Manufacturing Practice for Active Pharmaceutical Ingredients – ICH, published by the European Medicines Agency
Directive 2014/34/EU on equipment for potentially explosive atmospheres (ATEX), summary – EUR-Lex
This guide is general information. Each still is selected for the solvents, contaminants, volumes and the site's hazardous-area classification.





Comments