top of page

Building a PVT and Special Core Analysis Laboratory: Cells, Pumps and Core Holders

Writer: Tech Inc
Tech Inc
5 days ago
2 min read

At a glance. Reservoir studies need fluid properties and rock-fluid properties measured at reservoir pressure and temperature. Around the PVT apparatus sit recombination cells, a slim-tube apparatus for minimum miscibility pressure and a pendant-drop cell for interfacial tension. Around the core-flood rig sit core holders, relative-permeability equipment and ageing cells. Precision pumps drive all of them.

Fluid side

  • Recombination cells rebuild reservoir fluid from separator oil and gas samples.

  • Slim-tube apparatus measures the minimum miscibility pressure of an injection gas, a method widely used since Yellig and Metcalfe's CO2 work.

  • Pendant-drop cells measure interfacial tension from the shape of a drop at pressure.

  • High-pressure viscometers, gasometers and flash separators complete the fluid properties.

Rock side

  • Core holders – Hassler, tri-axial or X-ray-transparent – hold the core under confining pressure.

  • Relative permeability is measured by steady-state co-injection or by unsteady-state displacement, analysed with the Johnson–Bossler–Naumann method or history matching.

  • Ageing cells hold cores in crude oil at reservoir temperature for weeks to restore wettability first.

Pumps

Dual-cylinder positive-displacement pumps give continuous, pulse-free flow and measure delivered volume precisely, which saturation and recovery calculations depend on. Floating-piston transfer vessels keep brine and crude out of the pumps.

Planning the laboratory

Match pressure ratings across cells, pumps and holders; choose wetted materials for CO2 and H2S; and plan the oven space, data logging and safety venting as one system.

Where Tech Inc. equipment fits

Sources

This guide is general information. Laboratory design follows the study plan and the operator's procedures.

Comments


bottom of page